Forum Replies Created
-
Posts
-
Re: Hoover vtc 5911nb
Are you finding moisture i the drum after only 1 use if so it could be a problem. If you are constantly use the dryer load after load you will get moisture as the dryer needs time to cool before another load goes in
Re: Cbn2222 brushes size changed
Simple solution is to use a com stick to bed brushes in on motor and qualtex pattern brushes are a waste of time the cbn2222 are the only pattern brush I purchase I only use genuine rather customer not call me back in a year for same fault by using pattern parts.
Re: Main oven going out? – BEKO SCG 7521 W
It is more than likely to be a thermocouple but gas safe insist this is done by a registered engineer, regarding cost that depends on whoever you call and that there Labour charge is.
Re: DYN9164DPG/L1-80 E15 any advice appreciated
As this I a electronic component it can fail at any time on any machine, reprogramming isn’t a option for you as you would need to contacted Hoover for this see how much the programmer part is in the online shop
Re: DYN9164DPG/L1-80 E15 any advice appreciated
Unfortunately this is a main pcb fault without the programmer Hoover use you can’t even try to reprogram the pcb
Re: lg Washing machine
The side panels can be removed on these Dave have had a coin through the outer tub on 1 of these but it was hard to find as the sides have sound dampening which can absorb some of the water they are a nightmare to work on no room whatsoever Kai
Re: Guidance on premature failure of replacement bearings
No one has mention that the bearing housing where the bearings sit could be shot this is a possibility where the bearings are knocked in could be a lose fit so could require a new rear half where the bearings are press in ready.
Re: Gorenje WA7439 (Art: 392588/02) W/M Motor
Yes the ceset 1 will fit I’ve done loads under insurance on different models
Re: Hoover DYN 8164D – lights on but no action
As long as it has the same amount of connectors for the motor plug it will probably fit
Re: Hoover DYN 8164D – lights on but no action
Ok then it’s the newer type with rectifier built in, 2 possible culprits motor or main pcb check if the door locks I am sure the motor can affect door lock like the newer hotpoints. If you have the 3100 number I can check on Hoover’s website which module is fitted along with a part number for pcb or motor, you can fit any 1600 dc motor on this machine from older models as I’ve done it. There are 10 different models with dyn8164d each with a different 3100 number. Kai
Re: Siemens TD WT34V397GB/02 No Heat
If you want to be on safe side change the front and back sensors I know the 1 on the heater does give trouble from time to time
Re: Hoover DYN 8164D – lights on but no action
And did you check the dc rectifier bottom left corner at the back?
Re: Hoover DYN 8164D – lights on but no action
As long as the machine megs over 5mohms that’s hoovers standard does the door lock?
