Forum Replies Created
-
Posts
-
Re: Candy Tumble Dryer not heating
There are 2 stats 1 on the heater 1 on the front plus 2 ntcs 1 on the heater and 1 on the front should have continuity through the 2 stats 0.5ohms and 0.5ohms on the rear ntc as well the front ntc is common to go on these thou, hope this advises you where to look
Re: hotpoint dryer cdn7000 trips fuse box
It’s a current model sold but euronics as Dave has said probably water gone onto heater , I would wait no get md done
Re: PAT tester damages Siemens dishwasher module?
well pat testing for a earth fault on Bosch appliances is a total waste of time in my opinion as I’ve been to so many with a earth fault on motor which a pat test does not pick up I had 1 last week which didn’t pick up low insulation on motor pass pat test motor was tripping electric. And the ex Bosch engineer I work with doesn’t use 1 on Bosch appliances which I found hard to believe
Re: PAT tester damages Siemens dishwasher module?
Is your pat tester set to 500v rather than 1000v for pat testing as I’ve damaged modules on washer testing at 1000v kai
Re: Hoover wm no stop
What heater have you replaced it with was it genuine and did you replace the ntc aswell,if so check motor kai
Re: Beko c/tdryer DCU6130W
I’ve had this same problem on a beko dcu7230 the thermistor has taken the board out, 1 other thing have you put wet cloths in as the heater works through the sensor kai
Re: Candy GVW 1585TC3W-80 Washer Dryer HELP PLEASE !!!
Need to be able to download updates from giastech only option is knowing a engineer to do it for you or may be able to do it through giastech on connect not sure about that thou, Why I say the heater is the length is different on the 1 that’s on the machine compared to the p/n I give you,if you had taken these out of circuit and run the machine surely a fault would have come up, even if you met is out of date why didn’t you plug it in to read for any error as that will still work plus you have a function on there call boards manager which can give you part numbers for modules.
Re: Candy GVW 1585TC3W-80 Washer Dryer HELP PLEASE !!!
If you have a up to date mem loader and the module you have is the same the board can be re programmed to any washer dryer with that module fact! I think you have a selection issue I had a candy washer dryer and the dryer would come on no matter what programme you selected if the heater isn’t megging out at ol infinity I would look at changing that 1st sorted out the one I had part number for heater is HVR41042459 as they are having problems with the heaters check the wattage of heater 1st,hope this helps you kai ex gias engineer (Hoover)
Re: Qualtex Account Closure
I have been concerned that they would close my account I emailed the rep today she replied with someone from accounts would contact me. I don’t really get near £75.00 per month as work has been up and down and shop around for best prices, only thing that would bother me is connect having more business,when they had a rep in my area Mark most of my parts where ordered with them. Kai
Re: Samsung WF1114XBD/XEU Error 3E
I have put that part number into connect and it comes up obsolete
