Forum Replies Created
-
Posts
-
Re: siemens wxlm
The element and valves checked out okay.
Machine has been replaced. Thanks for your advice.Re: Neff Dishwasher S54m45x5gb/01
you were correct , it was the Jug. now sorted.
Thankyou very much.Re: Neff Intergrated Double Oven
Its probably starts with a B not a V.
When you say everything work except the fan do you mean the hot air fan, “circo fan”? Is the circo element heating?Thanks for the info. have been given the part number 61003693 but not sure if this correct from the diagram, as this has a ribbon attached and I thought the pcb didn’t. can anyone confirm.
Re: Bosch WFT7010 washer/dryer E-nr WFT7010GB/01
THESE MACHINE MUST BE OVER 10 YEARS OLD . THE FAULT CODES WERE NOT MUCH USE WHEN i DID THEM UNDER WARRANTEE.
wHAT IS THE FAULT?Re: Lofra cooker MX76MFI/C
I will look through some elements I’ve got on stock. I’m sure I’ll find something that is 1400w and similar shape.
It’s too new to scrap.
Thanks for the info.Re: BELLING OVEN GRILL ENERGY REG
Thanks for that information.
The customer is wanting to fit it himself so I would like the original if poss.
Does anyone know who stocks this manufacturer of energy regs? Strix, I believe. I am coming across them quite regularly.Re: HJA fridge freezer 6855
Stoves say its built by Beko and the part number is 5045172167378 which is over £50.
Does the Beko defrost timer part number 082625651, subs to the Stoves part? They look very similar.
i don’t fancy pulling this fridge freezer out of its housing again without the correct part.Re: HJA fridge freezer 6855
I’ve been advised that its a BEKO and did I check the defrost timer? It must be hiding in there somewhere. I think I know what the trouble is apart from my eyesight.
Re: neff washer
Thanks for that info. you were right. Valve open circuited. replaced. now working fine.
Re: Refrigeration ‘interim personnel certificate’
In the past when doing about 20 system jobs a week I have reclaimed the Gas using a recovery unit. When a van’s contents got stolen I reverted back to specialist Stirrup pumps called Rodger Rams. The reclaim cylinders would then get collected and i would be issued a form for the waste transfer.
I recently contacted my suppliers and they refused to collect the unused R12 and the reclaimed 134a as I had not purchased any gas for over 5 years and that I was required required to be registered before they could collect.
In the last year I got asked to do two 134a/ R12 systems so I do not want to invest money into training and perhaps replacing the Rodger Rams.
If I was to apply for an intermediate certificate would my application fail because I do not own a modern recovery unit?Any comments advice welcome.
