Forum Replies Created
-
Posts
-
Re: Zan ZWF14070W1 914226103(00)
If it does come to that, and they’re not too happy, and it’s under two years old, and they bought it from a big retailer, give them a written quote for repair and get them to contact the retailer. See this recent thread.
Mike.Re: Neff b1420
Think fan element is cheap enough for these. I’d try that first before imagining all sorts of complicated faults :wink:. Check fan speed too. If it seems a bit slow, pull cooker out and lubricate fan bearings.
Mike.Re: Can’t split Bosch Washer Tub
Take a dozen steak knives with you and insert them so as to hold the clips depressed at least half way round the drum. You can then quite easily lever it apart, allowing the knives to fall out as you do so. Zanussi tub screws will fit if you need any extra support when putting it back together. No need for a new seal, just bolster the old one up with silicone.:wink:
Mike.Re: Tricity Bendix BIW103w
Does it turn a load of washing at normal tumble speed? If so, I would think the armature is fine. Only thing I’ve had anything like Phidom describes, and not unusual, is motor attempting to turn a load of washing but unable to find the torque, so it judders then stops until the next attempt. That was usually the armature on Hotpoint 95’s and Hoover Logics but could sometimes be the module and occasionally the timer contacts. My guess is you’ve bought yourself a scrapper 🙁 .
Mike.Re: Tricity Bendix BIW103w
Talking off the top of my head and having never seen such a problem, I’d be surprised if a rotor could be pinned down to such a specific resistance under anything less than laboratory conditions. If brushes are long and commutator clean, I’d be inclined to think that was a red herring.
(Hmm. Is that measured through the brushes or direct across opposite segments? Might be significant if the latter.)
Mike.Re: diplomat dw adp8352
Parts reasonably priced on Connect. Could be worth getting both hinges, two springs and a cable if it saves you (+customer) a second trip.
Mike.Re: whirlpool ADG7561 spray arms not turning
Maybe it’s a gasket that fits at the inlet to top spray arm at back of cavity? If it came out, you’d get a loss of spray pressure.
Mike.Re: Tricity Bendix BIW103w
Actually, it looks like it uses a hybrid timer (?). Ako 513316?
Look at http://www.emwelec.co.uk and see common faults with that timer.
Mike.Re: LG WM1433 Washing Machine Module
The big rectangular one? I think it’ll be interference suppressor.
Mike.Re: Zanussi Bearings
PS http://www.electrolux.co.uk has all parts lists and explodeds online but you don’t get pictures :rolls: .
Mike.Re: Zanussi Bearings
Home – left menu> appliance type > make > choose model > press go > page with tabs, “all parts” / “mediator”.
Mike.
