Forum Replies Created
-
Posts
-
Re: Not working
“covers?” Is a puzzle put clearly the OP has done something to effect the door interlock, probably.
Re: Not working
I’m intrigued to known what clicks 3 times and bleeps after cleaning your rubber, the mind boggles. There’s a song that goes………knock three times on the ceiling….”
Re: Indesit PWDE 8148 S, F15 Error code.
robgil wrote:Because the machine is less than five years old it still has a free parts warranty and Indesit wanted 110 quid to come and fix it however for 13 quid a month they gave me a full unlimited warranty, so I went with that.
How interesting it would be to realise the outcome of this, though I doubt little more will be heard of robgil’s story. His admission of finding ……”several coins and half a pencil” gives a clue as to the abuse it had been subjected to so I wish him well in getting a successful resolve, albient a very costly excercise. A typical tale overall.
Re: Customer warranties on repairs
Yeah I get it Cras believe me. It is good to vent your frustration here after all. A Samsung too, bloody wonder it lasted a month never mind two years!
Re: Customer warranties on repairs
What! You don’t give lifetime guarantees? What’s the phone number of TS’s, I want to complain. 😉
Re: Faulty new beko grill element.
poe wrote:spoken to the suppliers (Connect) who say they have had no other ones returned.
Standard reply from Connect. The best defence is denial after all. In truth we know differently don’t we. The fact is all oven elements irrespective of make, pattern or genucrap all are a risky investment. Your tale typical, try getting a refund from Connect and we will all follow on behind you. 😉
Re: NEFF INDUCTION HOB PROBLEMS WITH REPAIR
Cazza0104 wrote:Thanks – appreciate your time!
Do come back and give us an update if you will. 😀
Re: smeg oven not working
fever7 wrote:Se335ss/1 is the model number. Apologies, my mistake.
In that case the correct TOC is THIS one.Re: smeg oven not working
Well you didn’t tell us the model number of this Smeg oven but generally a TOC only operates when temperature exceeds the pre-set limit (say 180Celsius). So from cold ( i.e on switch on) there’s no way that’s going to happen to such a part. So I have no clue what’s going on there TBH. 🙁
Re: Zanussi ZDC 37200W no heat
GlenM wrote:Probably worth replacing it at £27 then?
Well it reads 1Kohm and it should be 6Kohm so I’d say that would be a good move. 😀
Re: Hotpoint WT721 F08 error code
You are correct, the resistance across those terminals (measured in Kohms) will change as the temperature fluctuates up or down. 😀
Re: Zanussi ZDC 37200W no heat
GlenM wrote:Checked the machine again today. When it’s turned on there is a beep and the LED flashes green 3 times, then another beep and it flashes red 20 times. It then keeps beeping and flashing red 20 times repeatedly.
It must be going through a mental breakdown judging by that, blimey!
GlenM wrote:I took out the temperature probe to test the resistance and got a reading of 1.05 K Ohms at ambient temperature, which was probably about 18 – 20 degrees.
It should be around 6kohms at 20C 🙁
Re: smeg oven not working
You’ve not fitted the correct part I would think. You’ve sussed the fault for sure but the part you replaced it with is wrong. Try and source the right one.
