mikehha

Forum Replies Created

Viewing 15 posts - 136 through 150 (of 217 total)
1 2 3 … 9 10 11 … 13 14 15
  • Author
    Posts
  • February 14, 2017 at 5:44 pm in reply to: hoover dxc c48w3/1-80 #444776
    mikehha
    Participant

    Re: hoover dxc c48w3/1-80

    Thanks for your reply Kai. changed the top module which came with the rotary switch back now all I can get is the LED display just lights up in a clockwise rotation is this a set up fault do I need to program something or is this a test sequence?

    December 21, 2016 at 10:03 pm in reply to: Bosch sms50t22gb/34 #443216
    mikehha
    Participant

    Re: Bosch sms50t22gb/34

    Sold them a new m/c so will be taking this one back to workshop so watch this space!

    November 1, 2016 at 3:00 pm in reply to: lg f12b9QDA lights flashing #442323
    mikehha
    Participant

    Re: lg f12b9QDA lights flashing

    just to let everybody know that it was a pressure pipe holed

    September 29, 2016 at 4:32 pm in reply to: John Lewis JLTDC01 – 91609605600 #441375
    mikehha
    Participant

    Re: John Lewis JLTDC01 – 91609605600

    low on gas maybe?

    September 10, 2016 at 7:59 am in reply to: bosch wae24060 #440844
    mikehha
    Participant

    Re: bosch wae24060

    what ohms reading should I be getting across the ntc at room temp. Have you ever had a ntc fail

    August 2, 2016 at 6:30 pm in reply to: zanussi zwf14581w 914522628 #439863
    mikehha
    Participant

    Re: zanussi zwf14581w 914522628

    Thanks Martin will go back and check for broken wire.

    July 26, 2016 at 7:34 am in reply to: bosch s41e50w0gb/03 #439123
    mikehha
    Participant

    Re: bosch s41e50w0gb/03

    Just got back from hoilday, martin, so sorry for the delay. have allready checked board for damage and cant see any.but there has been water on the plastic case.

    June 6, 2016 at 3:54 pm in reply to: zdt12011 d/w #436135
    mikehha
    Participant

    Re: zdt12011 d/w

    can you post the pressure switch part no thanks mike.

    February 16, 2016 at 5:45 pm in reply to: Whirlpool t/l 3lwtw55560ywg #435396
    mikehha
    Participant

    Re: Whirlpool t/l 3lwtw55560ywg

    thanks for the quick reply
    this is an american style one but it dosnt have the large paddle in middle its one of the new ones with a large disk in the bottom. Its cr p its not as good as the old one.

    October 19, 2015 at 4:23 pm in reply to: So how do I drain a hotpoint and not ruin the board? #431043
    mikehha
    Participant

    Re: So how do I drain a hotpoint and not ruin the board?

    Had the same problem 2 colour catchers stuck in the filter m/c would not drain ended up sending the board to emw to get it re-programmed. I tried all the reset procedures and got nowhere so how do you drain these bl….. m/cs

    October 19, 2015 at 3:52 pm in reply to: bosch wtv74307 no heat #430984
    mikehha
    Participant

    Re: bosch wtv74307 no heat

    .035 meg or 35k a little bit high. cant seem to find the part no for the ntc even thoough thay give it a drawing no of 0207.

    September 30, 2015 at 4:43 pm in reply to: Bosch DW SMS69L02GB no heat #430618
    mikehha
    Participant

    Re: Bosch DW SMS69L02GB no heat

    easy to test with the righthand side panel off just make sure that the m/c is not leaking as the water in the bottom blows the heater

    September 17, 2015 at 10:02 am in reply to: Booby-trapped Hotpoint Washers #430355
    mikehha
    Participant

    Re: Booby-trapped Hotpoint Washers

    so if the customer drained the m/c over the floor to remove a sock or colour catcher they would have to ring hotpoint to come and reprogram!I can see hpt engineers running all over the place.

    September 9, 2015 at 1:59 pm in reply to: bosch dishwasher heat circ pump #430153
    mikehha
    Participant

    Re: bosch dishwasher heat circ pump

    I think you are right there was water in the bottom because the tub/tank was leaking

    July 6, 2015 at 7:51 am in reply to: candy csd69 s #428640
    mikehha
    Participant

    Re: candy csd69 s

    Maney thanks for the quick reply . mike

  • Author
    Posts
Viewing 15 posts - 136 through 150 (of 217 total)
1 2 3 … 9 10 11 … 13 14 15