[mikehha]

Re: aeg F77012wop 91141494/05

come on all you zanussi engineers one of you must have come across this fault.

[mikehha]

Re: aeg f34502v10 dw 91153911400

dave How do you get in to the service mode on this m/c thanks mike

[mikehha]

Re: aeg f34502v10 dw 91153911400

no lights flash it just stays on the heat program for three hours then the next wash it might be fine but I dont think it gets to the correct temperature.Have had the board out to check for dry joints also checked the relay.But I could be checking on a good day.
mike

[mikehha]

Re: Bosch sgs46e22gb/01

Thanks Martin .have told the customer to go on and use it.might fit another jug in the new year.
All of you Have a very happy Christmas.
Mike

[mikehha]

Re: Bosch sgs46e22gb/01

You know I doubt it myself so took out the jug again just to check.but I didn’t check the cables but surely not?.

[mikehha]

Re: Bosch sgs46e22gb/01

Sorry Martin not this time . This is the cleanest dishwasher I have seen it’s 10 years old and there is not even any muck in the air break. (Matrix)

[mikehha]

Re: beko wmb71642w

just a quick update fitted the pressure sensor it still stops after the wash wont go onto the rinse no fault code logged (thanks for the info electrofix).just 24 min on timer and the tap symbol flashing.Which are the YF1 buttons.

[mikehha]

Re: Lamina Dishwasher LAM8601

did you sort this problem? I have the same problem . no water underneath in the tray lights just flash then dead.

[mikehha]

Re: beko wi1573

many thanks for the info dave will store it away for a rainy day.The information you sent seems to be for a 3phase motor mine is brushed. but it gave me the jist of the fault codes and where to look so again many thanks
mike

[mikehha]

Re: more changes at Qualtex

opps silly me I mean LM electrical

[mikehha]

Re: more changes at Qualtex

LF electrical owned by Qualtex. It’s funny how the prices from LF are cheaper than qualtex

[mikehha]

Re: more changes at Qualtex

looks like connect , masterpart and europart will be getting more of my business then

[mikehha]

Re: whirlpool adp4601 851150415850

Many thanks for the info Dave. But I am still confused fitted new motor C00311149 motor pulses then pumps out and stops. Fitted the old motor with the impeller araldited in place and m/c works. The only thing I can find is old motor 29.9ohms new motor 70.1ohms would the board think it was pulling too much power so shutting the program down but not giving a fault code.
mike

[mikehha]

Re: bosch wvd24520

What a stupid idea! what engineer would design something that is going to make the m/c be scrapped.

[mikehha]

Re: samsung washer motor problem

dave my samsung dose the same thing always has done from brand new I thought that it was supposed to

[Author]

Posts