Forum Replies Created
-
Posts
-
Re: Miele W828
Ok, if you have shorts the inlet valve, you have probably damaged something on the board..you should have a circuit diagram tucked away in the machine somewhere, which should tell you what you may possibly have blown on the board…
As to the initial fault i can only guess at a leaky pressure hose, or faulty pressure switch..which as you know is located on the front board of the user panel..
I have a A3 size enlargement here of my own miele w829 which only differs by spin speed i think, so will check this out for you.. Is it the type with 3 inlet valves? If so would probably need to know which one you shorted out..
Martin
Re: Miele W526
Good point! I did explain this to the customer at first, but she was adamant that it had a problem
So i have since tried it with a half load, and a full load..on the full load it does the full time initially shown.. So will put it down to customer not putting enough in..
Did megger heater etc, but found no fault whatsoever..
Thanks for your input though..
Martin
Re: Hoover acm 15 washing machine spin problem
It will do a wash, but wont spin if brushes are worn.. Get them repalced and you should be ok.
Martin
Re: Hoover acm 15 washing machine spin problem
First thing to check would be the motor carbon brushes.
Martin
Re: Zanussi ZDT41 dishwasher
Ok thanks Martin,I will check that out first..never even gave that a thought..funny how u forget the basics sometimes!
M
Re: Miele W828
I have a miele w829 i use, and they dont take in a lot of water, but you can program them to take in more for either wash, or rinse.. Or both… Info in user manual here
See page 29 onwards
Hope this sorts it out
Martin
Re: Hoover HED 6612 Dishwasher
Update:
Turned out to be a burnt out controller board and @ £70 + labour costs customer decided to scrap it!
Martin
Re: Miele W828
Pretty sure the pressure switch on these is oart of thr front circuit board.
You may have a blockage in the pressure switch hose though.M
Re: Zanussi – drive belt placement on pulley
Sounds like you may have not fully tightened the drum pulley up to me?
M
Re: W864 flashing wash light on hot washes,
Could be the heater relay, which i believe is on the right hand side as you open the front up..
Martin
Re: Bosch SGS43A32GB/04 dishwasher
Cant say i have done many door seals on dishwashers… But wasnt as bad as i expected..
took me around 40 minutes in all..Thanks Martin!
