Forum Replies Created
-
Posts
-
Re: Hoover U3430 Overheats?
Try it without the filters…
If its ok, then its about time you had new filters..Martin
Re: Diplomat APL 1722 cooker
Yes, thats all i can seem to find on it, although the info is on the cooker itself..weird!
Thanks anyway
Martin
Re: Indesit Iwd61450
Ususally just slots in and you slide it to the front of drum…needs
a fair bit of force sometimes.. But they will click in to placeMartin
Re: Dyson DC18 hepa filter.
Sorry sound lile a differangmarrangement onmyour model
Try this
to remove the post motor filter, first remove the bin from the vacuum. Once you’ve done that, this part should clip or twist on and off. You’ll then be able to remove the post motor filter from its ‘cage’.
Martin
Re: Dyson DC18 hepa filter.
Put a screwdrive under the front facing clip on the cover, then theres a small,catch either side of the cover..these two are very brittle.prise those apart gently,and it should pop off..
Martin
Re: Electrolux Powerlite 1800W DEAD
Ive had a few miele cylinders in for motors, usually find they have fitted a pattern filter, after the original miele one has needed replacement..then never bother changing that pattern one ever again…
Had two in recently, that customers had left the “pattern” filter get so blocked…it had blown open the top cover and snapped the catch off..
Can honestly say i have never had a SEBO in for repair yet though..
Martin
Re: Dyson DC18 hepa filter.
If you mean the one fitted to the top of the clear bin, there is a catch at the front of the handle you use to pull the binnaway from body of the cleaner…filter is under there…its just a slot in fit…shouod pull out very easily
Martin
Re: Zanussi Turbodry 1050 WDS 1183 W – Starting Problems
Possibly the door interlock, or motor brushes..check brushes anyway if its over 3 year old
Martin
Re: Bearing change on a CDA C1930
Sorry just noticed its a CDA… Thought that was just part of the model number…im not familiar with this make, so will leave someone else answer you…
Martin
Re: hoover hnf6167 not spinning
Could be either a obstruction in pump, which is slowing down the drain times, therefore it causes a timeout on the spin cycle… So check for blockages in pump and also in hose end that goes in to the waste outlet… Would suggest removing outlet hose from sink connector and observing flow of water is good…
Get back to us
Martin
Re: Electrolux Powerlite 1800W DEAD
Beat cylinder in my opinion is any of the “Miele” range of cleaners
Martin
