Muv

Forum Replies Created

Viewing 15 posts - 541 through 555 (of 647 total)
1 2 3 … 36 37 38 … 42 43 44
  • Author
    Posts
  • September 3, 2012 at 9:32 am in reply to: Siemens Washer/dryer (WD61400GB) not spinning #380574
    Muv
    Participant

    Re: Siemens Washer/dryer (WD61400GB) not spinning

    Not sure if this machine has a tacho coil fitted..

    . That’s a small coil attached to the rear of the motor.. It will have 2wires coming from it.. And underneath this there is a permanent magnet attached to the motor spindle.. This is how the electronics recieve the relative speed info ..

    Check the wires are intact..and check for continuity of the coil using a multimeter…
    Also take coil off and check condition of the coil, and the magnet…

    Power off at all times!

    September 3, 2012 at 9:17 am in reply to: Siemens Washer/dryer (WD61400GB) not spinning #380572
    Muv
    Participant

    Re: Siemens Washer/dryer (WD61400GB) not spinning

    Does it attempt to spin, then slow down again? Or just no movement at all?

    September 2, 2012 at 4:04 pm in reply to: Hotpoint WMF740 #380532
    Muv
    Participant

    Re: Hotpoint WMF740

    Ok, thanks anyway

    August 31, 2012 at 11:10 am in reply to: Old hoover junior #371513
    Muv
    Participant

    Re: Old hoover junior

    I still have the machine, so will give it a try

    Thanks
    Martin

    August 31, 2012 at 10:19 am in reply to: Hoover HNC 160-80 #379937
    Muv
    Participant

    Re: Hoover HNC 160-80

    Thanks Colin… Had item today, and dryer now upand running again..


    Martin

    August 31, 2012 at 10:01 am in reply to: zannusi tc7103 poor drying #380420
    Muv
    Participant

    Re: zannusi tc7103 poor drying

    Have had a few of these with that fault, in the end I changed the heater… And have had no return calls…

    Martin

    August 22, 2012 at 10:55 am in reply to: Hoover HNC 160-80 #379935
    Muv
    Participant

    Re: Hoover HNC 160-80

    Turns out it is the thermostat on the exhaust, but looks like these are not available..
    It’s marked as 85 dg C..anyone know where to get them..

    Martin

    August 22, 2012 at 10:52 am in reply to: Hotpoint WM52 door lock forced open – HELP! #379988
    Muv
    Participant

    Re: Hotpoint WM52 door lock forced open – HELP!

    Check the door interlock is correctly located, if you had to force the screw back in, it’s probably not seated correctly… Or could be the catch on the inside of the door that locates Inside the interlock has been damaged..


    Martin

    August 22, 2012 at 10:50 am in reply to: Indesit door boots in general #379615
    Muv
    Participant

    Re: Indesit door boots in general

    Thanks, will give it a try on the next one.

    Martin

    August 21, 2012 at 9:19 pm in reply to: Indesit door boots in general #379613
    Muv
    Participant

    Re: Indesit door boots in general

    Would have thought it would just slide all over the place!

    August 21, 2012 at 6:59 pm in reply to: Hygena APL 8124 #379817
    Muv
    Participant

    Re: Hygena APL 8124

    Thanks you

    August 21, 2012 at 2:44 pm in reply to: Hoover HNC 160-80 #379934
    Muv
    Participant

    Re: Hoover HNC 160-80

    Thanks Colin..will pm you my email…

    Martin

    August 21, 2012 at 12:42 pm in reply to: Hoover HNC 160-80 #379932
    Muv
    Participant

    Re: Hoover HNC 160-80

    Thanks Colin

    Element,and stats, all checkout ok (forgot to mention that in previous post)

    Martin

    August 21, 2012 at 11:31 am in reply to: Indesit door boots in general #379609
    Muv
    Participant

    Re: Indesit door boots in general

    Well, been to fit the new clamp today..
    Definitely a lot easier using the method described by Jem… Or should that be “Gem”
    Took me just 25 minutes. Customer was as impressed as I was!

    Thanks again for that tip jem

    Martin

    August 21, 2012 at 9:53 am in reply to: Hygena APL 8124 #379814
    Muv
    Participant

    Re: Hygena APL 8124

    Anyone …….

  • Author
    Posts
Viewing 15 posts - 541 through 555 (of 647 total)
1 2 3 … 36 37 38 … 42 43 44