[nelson]

Re: Zanussi ZWF14070 continuous pumping

Thanks Bob and Seamy, I have arranged to go back armed with your advice 🙂

[nelson]

Re: Zanussi ZWF14070 continuous pumping

😳 sorry about that I thought I had already enabled the email feature.

[nelson]

Re: heater element removal

As you were Martin, I always debor them back in and in truth when I visit machines that have already had it done, they don’t cause me any heart ache, it generally peels away easily enough. In fact I find it quite relaxing, a bit like popping bubble wrap 😀

[nelson]

Re: Hotpoint WD440 no heat on wash

Johnny J, you the man 😀 It had obviously been fiddled with before I got to it as the Dryer heater and wash heater supplies were the wrong way around.

The only thing I have to do now is replace the stat on the dryer unit as it has gone o/c.

Thanks again.

Oh and thanks Banksie 😉

[nelson]

Re: Hotpoint WD440 no heat on wash

I think you may have just hit the nail on the head JJ. I will check it out today.

Cheers

[nelson]

Re: Hoover VHC391 Capacitor replacement

Thank you George and Martin

You have saved me from looking like an amateur in front of my neighbour….. oh how they gossip :rolls:

[nelson]

Re: Hotpoint wt540

Could be this….. http://www.ukwhitegoods.co.uk/modules.p … ic&t=51155

Hope that helps

🙂

[nelson]

Re: Beko WMA510 No spin amongst other things

Fitted a new module and everything is ok now 😀

Cheers Nige, I tried the motor wires before ordering the board.

[nelson]

Re: Hotpoint CTD85 – Wont start program

The door activation pin is ok, I should have mentoined that when the start button is pressed it beeps three times, also pressing and holding the start button (to cancel a program) also causes the machine to beep three times. 😕

[nelson]

Re: CDA CL994 no spin fault code E06

😀 Thanks Dave, this looks like it’s going to be fun 😯

[nelson]

Re: CDA CL994 no spin fault code E06

😳 errm I think I may have been checking the wrong bit, I removed the plastic cylinder that connects to the sump hose.

If the pressure chamber can only be accessed by removing the front balance weight and tub front, I haven’t checked it. 😳

I can’t remember if the front panel comes off the machine, I presume it does to enable access to the front weight etc.

[nelson]

Re: Samsung B1245s Drm spider/shaft

😳 I didn’t see that, I just searched on the model number.

Cheers Loaf, but I reckon at that price it’s going to be BER 😥

[nelson]

Re: hoover VHD8142 not having it

I tried a new door lock on this, but no luck. So ordered and fitted a new module and the job’s a good un 😀

Thanks for the help chaps

[nelson]

Re: Zanussi FJS1597W don’t know what else to look at???

Thanks Mike, I am going on holiday today, so I will pass the advice onto my partner, hopefully he will be able to resolve it.

Cheers

[nelson]

Re: hoover VHD8142 not having it

Thanks Martin, even though the door does actually lock?

Cheers

[Author]

Posts