Forum Replies Created
-
Posts
-
Re: Bosch WAB24161GB/01. E16 Fault
I think its hold the start button and one turn anti clockwise on the selector knob.
Re: Bosch Diswasher white gunge round filter
I’ve seen it on machines that have stopped heating or having problems with water levels. Also , do they use the quick wash more often than not?
Re: Bosch WTL6106GB/07 control panel removal
Normally a large flat bladed screwdriver under the bottom edge will help prise of the facia panel.
Re: Neff B1564NOGB/10 oven temperature issues.
Is the display resetting to 160*c after the temp has been set higher? It sounds like the temp is resetting to its default setting during use. Try setting the fan oven temperature to 180*c and playing around with the selector switch to see if you can recreate the fault. This might give you an idea If that’s what is actually occuring.
Re: Bosch interlocks, what is the difference?
Don’t know the difference tbh but I will say that we have the top one 00610147 as van stock as that’s the one we use most often.
Re: Bosch Dishwasher newly fitted heater/ motor blown
The diverter going can easily take out the triad on the control module so examine the board and see if you can see any of the 5 grouped triacs with damaged tops.
Re: Bosch Dishwasher SMS40T42UK/34 Check Water Light Flashin
It sounds like an e15 flood protection error code which would suggest a leak into the base. Are you sure there’s no water in the base? Before going down the control module fault , I’d be checking the actual switch on the flood protection device first.
Re: bosch cooker hinges
The only hinges where there is that kind of ‘mod’ that i know of are certain older fridge door hinges ?
Re: Neff Induction Hob
So you set a temp setting on a zone eg 9 on rear left and the 9 flashes. What happens if you put a saucepan on it ? Does the hob go dead , the 9 stop flashing or just not register the pan?
Re: Neff Induction Hob
I’d check to make sure that there isn’t a child lock set on it first. The brief flashing red lines immediately after switch on are normal.
Re: Drum bearing failure Bosch/Zanussi
The 10yr guarantee is for the brushless induction motors I believe.
Re: Bosch WIS24141GB Bearings failed within 1 year
Twoten wrote:
nomadPaul wrote:
did you know what the fd number is/was?FD: 9502
Hmmmmm…….I can’t say I’ve heard of a WIS failing so early due to bearings ? Hope it’s just one of those odd failures that sometimes happens.
Re: Bosch WKD28350GB/03
Tbh , I very much dislike these machines ! The condenser is prone to getting badly blocked and can be a pain to get to and clear . The fans also get blocked causing bad air flow. The inner airway where the dryer element sits can get fluffed up including the face of the temp limiter.
There is a fluff clean programme normally ignored by the customer even though a symbol appears on the display to remind them it needs carrying out. The earlier models were worse as the fluff clean was both to short on time and not a high enough water level. This was improved in later models but still not brilliant.
