Forum Replies Created
-
Posts
-
Re: Bosch WTE84301GB Getting too hot
Check the condenser fan on the RHS making sure it’s not blocked.
Re: Neff S51E50X1GB/24
Check the water level after approx 12 minutes. If it seems higher than usual, it may be the heat exchanger valve allowing water to overfill tank. If you can access the error codes , look for E08
Re: Bosch wtv 74308gb/10
Has the element been cleaned out ?(if it’s got the rear block type element)
Re: Bosch WAT4460GB/01
If it’s got a large module lowdown at the back, then that module may well be your problem.
Re: Siemens sn66m054 gb/50 dishwasher
If the door ropes/strings haven’t previously snapped , then I’d be pretty sure the bent inner door , if it’s adjacent to the hinges ,is the cause. Probably someone has fallen/stepped on the door when it was open.
Re: Neff D/W E15
If its a full metal Tank then it’s most likely to be the sump seal. They leak but normally only on the higher temp washes. There is an additional seal kit that can be fitted – in situ – or it requires a new improved sump.
Re: Siemens HB48054GB/02 OVen flashes 150
It sounds like it’s resetting to the default temp? IIRC , these are the electronic controlled ovens with a PTC as opposed to a mechanical stat so I’d be looking at either the switch selector or control/relay module.
Re: Bosch WAQ28461GB/15 FD 9403
99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure it’ll be the Heating element
Re: Neff S51E50X1GB/13
You put the white block/rope through the gap of the spring in an upright position then you pull the rope and the block goes sort of underneath
Re: Bosch won’t start?
Ask her to try and start it with the door open . If she gets the same 2 bleeps , it may well be the door lock faulty.
Re: bosch dishwasher e09
timdowning wrote:I’ve posted quite a few times on heat pump replacement.
Nice & simple can all be done through the front access panel.I’ve done *cough cough* a fair few but never through the front. Personally takes me 10/15 mins from the side although I know some of the lads can do them through the front. Do you leave the original hose clip in position or fit the new jubilee clip ?
