Penguin45

Forum Replies Created

Viewing 15 posts - 18,091 through 18,105 (of 19,678 total)
  • Author
    Posts
  • in reply to: Between the drums #132454
    Penguin45
    Participant

    Re: Between the drums

    It can be done Andy, by removing the heating element and going fishing.

    Power off first :plug:

    If you are not confident, check Repairs@ or Directories for a UKW repairer in your area.

    Regards,
    Penguin45.

    in reply to: Common Sense #132340
    Penguin45
    Participant

    Re: Common Sense

    Anyone got any thoughts about the original point of this thread – limiting run away Public threads?

    As for Yurtesen – Finnished? 😆

    Chris.

    in reply to: Ariston 1164t spins, but only under certain conditions. #132386
    Penguin45
    Participant

    Re: Ariston 1164t spins, but only under certain conditions.

    Roger,
    Can you check that model number again? There are a couple of 1146 machines, but can’t find an 1164.

    Ta,
    Penguin45.

    in reply to: Electrolux seems possessed!!! #132443
    Penguin45
    Participant

    Re: Electrolux seems possessed!!!

    The motor tacho generates a signal which can be read by the digiboard or tupperware box and so allows motor speed to be controlled. The magnetic armature has a habit of working loose over time and can cause the coil assembly round it to be pushed off. Eccentric things then start to happen….. Check on the end of the motor, with the power off.

    If no joy, engineer time.

    Regards,
    Penguin45.

    in reply to: Spares for Candy Hob PL330 #132068
    Penguin45
    Participant

    Re: Spares for Candy Hob PL330

    Correct – power off first……… Your multimeter can also be used to check whether the regulator is switching or not.

    Regards,
    Penguin45.

    in reply to: Dyson washing machine RIP #132314
    Penguin45
    Participant

    Re: Dyson washing machine RIP

    Whole thing was a bit cock-eyed in retrospect. Factory service for £58 inc parts was good, but for a grand, shouldn’t it have been reliable in the first place? For that money I’d have bought Miele and called them out if 5-7 years time.

    Chris.

    in reply to: Indesit WI101 simultaneously pumps and fills after 5 mins #131768
    Penguin45
    Participant

    Re: Indesit WI101 simultaneously pumps and fills after 5 min

    😳 Sorry Andy, missed this – he’s right – reading out of accepted “range”. 😳

    Chris.

    in reply to: Common Sense #132326
    Penguin45
    Participant

    Re: Common Sense

    Fair point Dave, but he’ll be back……..

    Not really the point – we ought to sort out some sort of “cut off” – a key phrase, an emoticon that the regular public forum posters recognise – something.

    In the mean time, let’s get the provisional wing of UKW to fit a tracker on Martins van and see where he goes over the next few weeks.

    Chris.

    in reply to: is there a decent washer dryer that dry’s well #132324
    Penguin45
    Participant

    Re: is there a decent washer dryer that dry’s well

    The wash water level on a WA110 is below the door seal, even allowing for what is absorbed into the wash load. From memory there’s a bit more in for rinse, but unless you select the wool programme you won’t see much water.

    Tumble dryer in the garage? Generally a cold place so vented steam will condense almost immediately. If the garage is empty it won’t matter, if you keep tools and gardening stuff in it a vent-out arrangement would be a good idea – or a condensing dryer. The blower type is simpler and a “Through the wall kit” will generally cost less than £20, although you do face the fun of fitting it.

    Regards,
    Penguin45.

    in reply to: is there a decent washer dryer that dry’s well #132322
    Penguin45
    Participant

    Re: is there a decent washer dryer that dry’s well

    It’s too late to type it all out again, so:


    http://www.ukwhitegoods.co.uk/modules.p … pic&t=4962

    will give you some idea. The machines are all limited in ability, the Zanussi ones do seem to be a bit more effective than most. Or, buy German and pay for the quality.

    Regards,
    Penguin45.

    in reply to: Indesit Dishwasher error code A05 #115152
    Penguin45
    Participant

    Re: Indesit Dishwasher error code A05

    It’s to do with the temperature control circuit. Sensor failure, wiring failure, electronic board failure all possibilities.

    Check Repairs@ or Directories for a repairer in your area.
    If you are going to have a look yourself, pull the plug first. :plug:

    Regards,
    Penguin45.

    in reply to: Ariston Margherita 2000 A1435 #126676
    Penguin45
    Participant

    Re: Ariston Margherita 2000 A1435

    Water level control problem – check for blockages in the lower air chamber, pressure hose integrity and action of pressure switch.

    Pull the plug before touching anything :plug:

    Regards,
    Penguin45.

    in reply to: Ariston LS620A #132304
    Penguin45
    Participant

    Re: Ariston LS620A

    http://www2.merloni.com/indesit/_pdf/manuals/

    Should do the trick.
    Regards,
    Penguin45.

    in reply to: Indesit WD12 UK F5 & F10 ??? #132288
    Penguin45
    Participant

    Re: Indesit WD12 UK F5 & F10 ???

    Check the dryer thermistor – weird things happen with that. Otherwise p/sw wiring or module.

    Chris.

    in reply to: Who charges what for what ?? #132083
    Penguin45
    Participant

    Re: Who charges what for what ??

    Poll unlikely to produce significant results based on UK. Problem is that “London and Home Counties” prices are likely to be 30-40{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} higher due to their significantly higher overheads compared with the more northern cities. Rural areas will be higher too, as they cover larger areas and can do fewer calls per day.

    In my own case, I’m very busy in a very small patch – heaven! But that’s not how it works for everyone………

    And – we have no regulation at all with regard to pricing, so we will always have a few, shall we say, taking advantage.

    Regards,
    Chris.

Viewing 15 posts - 18,091 through 18,105 (of 19,678 total)