[pmb]

Re: Bosch Dish keeps pumping

Fitted new anti flood assembly, but still the same,
So most be PCB

[pmb]

Re: Bosch Dish keeps pumping

It pumps with door open but I took micro switch off and checked it twice but
I will order flood switch assembly and hope its that

[pmb]

Re: Zanussi W/D dead no lights

I did check the Interlock but do you think that might have blown the PCB
If PCB is not pre programmed, I don’t wont to proceed.

[pmb]

Re: Zanussi W/D Dryer time shortened

Thanks Martin its all ok now,

[pmb]

Re: Zanussi W/D Dryer time shortened

I assumed NTC would be torpedo type, Three on heater duct all look like thermostate s
So is it the one in the front

[pmb]

Re: Zanussi W/D Dryer time shortened

The one in the lower hose from condenser to tub

[pmb]

Re: Hoover vhw654d-80 dead

Hi I fitted the new main pcb on this one today. The display occasionally comes on as it should when turned on but more often shows the small flicker then nothing as before. However now it has started a program (even when no display) which I can pause but doesn’t cancel when off is selected. I am next going to try a program selector switch unless anyone has a better idea?

[pmb]

Re: Bosch europart suspension

Just looked up on the bosch site and they are £31.03 each plus delivery, how are you coming up with £22
When I phone I normally get 15{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} discount, what do you get,not sure how to get trade discount online from bosch
I paid £27.17 + vat =£32.60 from connect last week
I was going to fit two of them for £80 total as I fitted a top spring recently

[pmb]

Re: Hoover vhw654d-80 dead

Thanks Tim, I checked all the wiring between pcb and both sensors and it was fine

[pmb]

Re: Hoover vhw654d-80 dead

Thanks suede head for getting back to me, there was no visible damage to the PCB ( I assume you meant PCB as this is a washer dryer) the price of the PCB is surprisingly cheap and is already programmed so I will give that a go

[pmb]

Re: Hoover fitting paddles

Just looked up paddles for this model and theirs two types so I will have to go back
And see which one, the ones on the machine are screwed in,
Can anyone tell me if one type is screwed and one clicked in place and are they
Interchangeable .

[pmb]

Re: Electrolux/IKEA RDW45

Thanks a lot criscold thats really helpful 😀

[pmb]

Re: Bosch W/D stuck on pause

Thanks everyone, It righted itself ?

[pmb]

Re: Bosch wvd24460gb/02

Thanks a lot Tim that is really helpful 😀 I will do that

[pmb]

Re: Bosch wvd24460gb/02

Hi thanks for getting back to me, no i didn’t clean the bottom. i felt that the airflow was good when i first tested the machine but decided to check the top end and ended up removing what was there and using a long brush to check lower. The one time i have ever removed the bottom i had a nightmare getting it back on is there an easy way to do these? When the machine overheats does it stop like this?

[Author]

Posts