Forum Replies Created
-
Posts
-
Re: Beko dryer belt
Sorry everyone I got the model wrong, it is DCU8230, well done Geoff for working it out.
Thanks for the number I was hoping I could get belt on its own without pulley as its only 18 months oldRe: Beko PCB need part number
Thanks don
No one has it in stock, So will have to wait for connect to get it back in stockRe: Izettle chip and pin
I like to be payed when I do the job,
when you take PayPal payments is it all done later when you get to the office
If that’s the case it would be the same as using BACs and just giving them your bank details and checking later that they payed it in.
It’s nice to leave a job and know its finished.Re: bosch dishwasher sgs3062gb/01 spray arms sticking
Hi is the machine filling with enough water? it should be lapping the salt lid. if it is I would try the spray arms. I have never had to change the bottom one but the top ones do wear. I hope this helps
Re: Baumatic door handle
Found it on europart / Maddocks at a great price of £3.99.
I don’t use Europart very much and I forget about them, but I most start comparing their
Prices, I also ordered some Askol pumps at a good price.Re: Whirlpool W/D spin pressure S/W
Sorry my mistake its Candy
If its single level then it’s most likely the PCB at fault
ThanksRe: Bosch condenser dryer heat
That’s what I thought, I did check for dry joints but none,
I think I will have to refund some moneyRe: Zanussi zwd16270w1 e73
Thanks guys for getting back to me. I have thoroughly checked the wiring and plug twice but it is all fine. I must admit I didn’t check the dryer heater as the e73 fault is so specific and other faults I have had with the element have been different, but I should have done shouldn’t i. Thanks again
Re: Bosch dw sgs46e22gb/01
:salute: Thanks alot Martin i will, i have never had one intermittantly cause problems like this so i over looked it.
Re: Bosch replaced interlock but still shows faulty
Just looked up Module and there are two a power module and a operating module.
It would be good to know what faults happen on which module.Re: fridge not cool
Hi eldar thanks for getting back to me, the only thermostat i can see is inside the fridge and only has numbers on it, i have turned it down from 7 to 5 and will check it later 🙂
