[repman]

Re: Zanusasi FJ1254W Reading the fault code

It is E61 heating time out so if the heater and ntc check out its time to get the soldering iron on the board

jim

[repman]

Re: Ignis AKL 827/WH temp light never goes off

1st the thermostat sounds as if needs renewing if you can turn it beyond 0deg backwards
2nd when the temp light is on the elements (2) should heat up
one is at the top of the oven cavity and the second,which is the usual suspect for failure,is under the base of the cavity-after a couple of minutes of being switched on you should feel the floor warming

jim

[repman]

Re: Zanussi heating problem

if you open the door and put your hand inside upwards and to the front you should feel it ,tou may like to use a mirror to see it then you will see why you need to be able to stand on tour head to access it-good luck

jim

[repman]

Re: Zanussi heating problem

HI ITS PROBABLY THE THERMOSTAT INSIDE DRUM ABOVE FRONT ,HOPE YOU CAN STAND ON YOUR HEAD!

[repman]

Re: hotpoint ctd00 belt keeps snapin

check the timer make sure it does not snatch the belt when reversing,you may have to watch it for quite a while

[repman]

Re: Hotpoint TCD980 Tumble Dryer stats

you are right that the higher temp mark is the safety stat

[repman]

Re: Sugru.

thats it then,we are all out of work now

[repman]

Re: door seal clamp/spring

I use a third hand clamp which is spring loaded to hold the spring at one point giving you both hands back,if you google ROU38332 you can see the type i’m useing

[repman]

Re: Washing machine samsung p1453

hi i think you will be fine with a new pump-fault code 5E is not draining
jim

[repman]

Re: Top oven and main oven failure on Creda topline 49723

if this cooker has a clock have you set it after restoring power?
clock on auto will kill both ovens.

[repman]

Re: Bosch oven HBN131550B/02 Info

got hold of bosch tech and managed to obtain a diagram but it was not very forthcoming.why do they have to be so protective?
anyway job done

thanks both

jim

[repman]

Re: NEFF MULTIFUNCTION OVEN COMBI B6784N0GB/01 FD8709

Check for cracked magnets on the magnetron

[repman]

Re: Ignis AKL 827/WH temp light never goes off

Am I correct in saying this light is a temp light and something is up with the oven for it to always stay on when the oven is turned on and not go out when the temp has been reached?

i think you are correct as the lamp is conected to the elements when oven is switced on
jim

[repman]

Re: Zanussi ZWD12270W Not starting

I’m not sure on this one. I couldn’t find a way of doing it

hold start/pause plus nearest option button whilst turning machine on 1 place clockwise then when in diagnostics read alarm from position 10 of selector

[repman]

Re: Hotpoint TCD970K Dryer

from s.n you give it should be c00260045

jim

[Author]

Posts