Forum Replies Created
-
Posts
-
Re: Zanussi ZDC47100w Condenser Dryer cuts out!
yes that sounds like you’ve found it,two wires on the plug
Jim
Re: Zanussi ZDC47100w Condenser Dryer cuts out!
sequence of 7 red flashes, followed by 1 red flash (I believe an E71 error code?)
If you mean 1green flash then yes is is fc71 NTC flt . It should read about 6 K at 20 deg
It’s mounted in the air duct at bottom after r/h side is removed.Jim
Re: Indesit WIL103 – adding hot water
why do you want to redesign the machine ?It is only a cold fill but the water is heated during the wash
Re: Zanussi ZDC 5355W condenser (sensor) dryer not heating
All the results you have just posted are correct ,the two stats on the heater are limit stats and go open circuit at a fixed temp
Jim
Re: JLBID0906 Circular fan oven element not switching off.
you have not said but have you done an insulation test?
the fan element can be duff.jim
Re: ELECTROLUX 949711937
Dont think this is going to help but—
The table below describes the various error codes:
ERROR CODE DESCRIPTION OF THE CAUSE
F02 Door lock system
(featured only on pyrolytic ovens).
F03 EEPROM Memory on Control Unit.
F04 Oven sensor temperature range exceeded
(condition occurs for more than 5 seconds).
F05 Temperature safety limit exceeded
> 350°C on normal ovens.
> 530°C on pyrolytic ovens.
(condition occurs for more than 10 seconds).
F08 Communication interruption between Control unit and
power board.
F09 Software compatibility between Control unit and power
board.
F10 Faulty triac (on power board)jim
Re: Smeg A2 Electrical Smell
a poor/bad joint will create heat which in turn makes the joint worse so it gets even hotter then you end up with what you had.
Jim
Re: Hotpoint td32p Condenser dryer
if you mean TDC32 then the relay behind the control panel is the usual suspect for this type of fault.
Jim
Re: Smeg A2 Electrical Smell
do you think I should cut back some of the wire and fit a new spade connector?
Thanks
Yep,make it look like new or next big cook up will be the terminal block again
Jim.
Re: DWH B10 IKEA WHIRLPOOL 7 FLASHES
I’ve had them work with a magnet out of m/c and then work for a short time once replaced, think you use a stronger magnet to test with.90{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} certain it will be your problem.
Jim
Re: Smeg A2 Electrical Smell
It started with a bad joint and it will continue unless you replace the block
Jim
