Forum Replies Created
-
Posts
-
Re: Beko WMA520W
Sounds like a water level sensor failure, check the water solenoids & pressure switch.
To be certain go in to diagnostics & check the fault code.
Re: aeg fridge freezer
Most likely the condenser fan seized up & the compressor overheated, theres a p.c.b (inverter board) attached to compressor which has a thermal link that goes o/c.
Re: Miele WT2670 clogged drain hole
You can try cleaning the drain holes with something flexible like a pipe cleaner, cotton bud etc.
Re: Miele W821 W/M Rinse Hold error code
door may just need a smear of grease on latch/catch, just check that door pull cord that goes down to filter door isn’t catching on anything as this can cause fault described
Re: Miele W821 W/M Rinse Hold error code
Rinse l.e.d flashing denotes drive failure, check the usual, carbon brushes, cable connection to motor etc.
Re: Belling IDW603
Only one digit used in fault code, likely its E3, normally a heater related problem, either not heating because of not enough water in appliance or over heating because sticking relay on board.
Re: Beko WME 8227 W washing machine
Check brushes are making good contact, take them off rub end with very fine emery paper & same for armature. Then give it a go, run it on spin a few times to bed in brushes if motor is o.k.
Re: Miele washing machine
Rinse light flashing denotes fault code of no signal from motor tacho. Check usual, brushes may be worn, drum seized & not able to turn etc. Worst case, P.C.B could be faulty.
Re: Miele T230C Tumble Dryer
Yes theres a non return valve system, best thing to do is run a cable direct to pump from a plug just to test that the pump runs ok & theres no blockage. Fluff/dirt can foul the switch & pump inlet & cause fault described.
Re: Belling Kengsington 90
Need the product number 44444???? to be certain, but theres an ignition switch part number 081811101 that may does Kensington 444449016
Re: Miele W304 motor wash path control
You can look down on to top of water path control & see through little window, theres a symbol for prewash, wash & conditioner which should be visible when motor moves to correct place, this then makes switch & it fills.
Have gotten parts off Danish firm NettoParts years ago as they were cheaper than Miele direct, for instance a heater costing £55 off Miele cost £25 off Netto, they’re not the quickest though & from reading other posts on here sometimes parts don’t arrive so thread with care.
Nettoparts ApS Tel. +45 60211463
Finlandsgade 26 Fax.+45 56361417
DK-4690 Haslev
Denmark
VAT.no.26862108
