[Seamy]

Re: Zanussi Tumble Dryer TD160 – parts help

Diagram shows internal connection of 2&3 pins of t’stat .

[Seamy]

Re: Zanussi W/D ZKI225 914606007/02

Low resistance on dryer heating element causes the p.c.b to go blank on these sometimes, disconnect cables off element & tape up safely and securely, test to see if it powers up ok with dryer elements out of circuit.

[Seamy]

Re: Broken Hob Glass – Cracked Whilst Cooking??

Yeah, looks very much like impact damage to point where piece is missing.

[Seamy]

Re: Zanussi ZDT21001FA, need advice

Yep Pressure Sensor kit required

[Seamy]

Re: Zanussi zwg7120k filter

No filter for customer to access, they say this machine has a “self cleaning” pump.

[Seamy]

Re: Zanussi ZRB227W0 Fridge Freezer Problem

GBNeil wrote:Hi,

The compressor gets hot and I don’t think the fan is operating.
.

The appliance that you describe doesn’t have a fan as far as i can see ❗
So i’d imagine the compressor has failed, most likely not worth repairing.

[Seamy]

Re: Beko WMI71641 Washing Machine Not responding

Most likely a problem with a component has blown p.c.b, which means you have to test components of appliance to get problem.
If you don’t feel competant, get an engineer to do it as it could prove costly throwing parts at it.

[Seamy]

Re: beko wm95135

Don’t know what you mean by selector switch, this has a p.c.b with knob just pushes directly onto a pot on the board, not ever seen selector pot available on its own.

Anyway part number for board is 2431702211 depends on ser’ num’ most likely.

[Seamy]

Re: Beko Tumble Dryer DCU9330W

Tip appliance up, look underneath to rear, there’s a short 3-4 inch long ribbed grey pipe, take it off & clear it out, it normally blocks with fluff, which can cause problems with water drainage to tank.
Other problems with this model is heater going low to earth, if this is so, heater element needs changed.

[Seamy]

Re: ZWH6160P

Yep EF5, unbalanced load

[Seamy]

Re: lux oven lamp

3192560039 25W Lamp
3192560013 Lampholder complete

[Seamy]

Re: Lamona dishwasher

This could take a while……

perhaps you could state which 3 lights

[Seamy]

Re: Beko DRCS68W – Noisy in reverse only

Take belt off & look for motor judder, see if its actually drum causing noise or motor,
may be faulty motor, check mounts, tensioner etc

[Seamy]

Re: Smeg Int’ DW (DI 612 CA) no heat

Safety pressure system activated (E2)
looks like going by that ? did’nt seem to have overfilling, no water in base, float switch was not activated

[Seamy]

Re: AEG Favorit F55010 VI not heating up

Fit a new P.C.B, i’d dare to advise

[Author]

Posts