[Seamy]

Re: AEG Favorit 40850 Error 30

Yes e30 is a float switch error, it could however be fault in control p.c.b, wiring fault, sticking float or damaged polystyrene float giving an incorrect signal that theres water there.

[Seamy]

Re: Fridge not cold and freezer too cold

Sounds like the fan is not running correctly or that there a blockage in the vent to fridge.

[Seamy]

Re: Water dripping steadily into ice maker

Sounds like a faulty water solenoid valve.
For spares try :-

http://quinnspares.com

[Seamy]

Re: Zanussi FDJR 1666 w won’t spin

Model not recognised, is it a FJDR1666W per chance?
Best to quote 9 digit PNC code..
Does it flash lights when it doesn’t spin, error code?

[Seamy]

Re: Beko WME8227W making grinding noises intermittently

I am a firm believer that lingerie should be treated with respect and only hand washed.
I remember once having the conversation with Priest who had a bra wire stuck in his machine, his embarrassment was priceless. 😆

[Seamy]

Re: AEG Washing Machine L64810

E-mailed you some info

[Seamy]

Re: Bosch HBN7050GB/01 loud pop & RCD tripped, main oven

Check fan is turning o.k & not noisy or slowing down. Excess grease on shaft & bearings can cause them to slow down & elements go pop. Elements have been known to go pop on these for no obvious reason.

[Seamy]

Re: hotpoint fridge freezer defrost drain blocked

Small jug of boiling water, carefully pour it into drain hose, it should melt it.

[Seamy]

Re: stoves induction hob ramge cooker model number MODEL 444

Model num’ is not recognised, think it may be incorrectly installed & not enough air getting through to cool appliance, possibly going out on overheat.

Important instructions on installation are not always read by kitchen fitters.

[Seamy]

Re: Zanussi ZWD12270W Wash/Drier – M/C Dead

PCBs on these have been going dead with no burn marks, check the usual suspects, valves, heaters, mtor, interlock before fitting new PCB

[Seamy]

Re: beko wma 1512s skipping programs

Sometimes the motor just needs cleaning, bad contact of brushes to armature or carbon dust on brush holder can give strange faults.

Before you go ordering a timer, they do advance on after timer is set & started, this is normal. It takes info at start point & advanced on a good bit, looks like its a fault but its how they work.

[Seamy]

Re: Belling Countrychef 924 G92491 Static Oven switch

http://www.gdhaonline.co.uk/Belling/Accessories.aspx

try this enter details in model search , look at pictures, theres countrychefs in different colours, sizes & fuels, ring there parts dept’, they’re usually able to help

[Seamy]

Re: AEG Competence 52580B

Element likely to be at fault

[Seamy]

Re: times are hard

Had the same a few days ago, lady saying her Indesh1t is done & will I buy it for parts

[Seamy]

Re: Creda SolarGlo on the Go Slow !!

There are lots of engineers in N.I, have you tried ringing your local engineer

[Author]

Posts