[Seamy]

Re: Beko WMD78144 Washing Machine

Think you would have to suspect a dodgy motor if its unable to turn the drum loaded. Asuming the appliance has the correct supply to it & the connections have been checked etc.

[Seamy]

Re: Beko WMD78144 Washing Machine

How old is the said appliance. possible loose belt, brushes worn etc.

[Seamy]

Re: Beko BC50F S/N 1110178806

Whats the problem you are having with it?

[Seamy]

Re: Beko CTD MODEL.DCU7230

NTC on heater is prone to going low to earth, P.C.Bs also prone to failure, quote for heater & P.C.B to be safe

[Seamy]

Re: Beko DWD 4311

From experience of them found to be problematic with filling. Most problems have been loom breakage from flowmeter to p.c.b. Some have had to have to have flowmeter replaced & some problems with loom at overflow float switch, few circulation pump motor or P.C.B for this type of problem.

[Seamy]

Re: Beko DWD 4311

How do you know its filling or not filling to correct level, its a counter that counts pulses for every litre or part there-of. If it is a little short of pulses in the allocated time, it aborts programme without starting the circulation pump.

[Seamy]

Re: New cyber spy on Smartphones

What will they think of next, square eggs?

[Seamy]

Re: belling dishwasher idw604 error code e3

Mostly a P.C.B error, sticking relay, E3 means the heater is detected on when it should’nt be.

[Seamy]

Re: AEG Santo 76378-KG1 Larder Fridge

Occasional bubbling might indicate low gas level.

[Seamy]

Re: NEW WORLD COOKER NW551ETC

083157013 KNOB nw fs e grill blk/chr 1
083157010 KNOB fs elec h/p/ blk/chr 4
083157008 KNOB fs elec m/oven blk/chr 1

[Seamy]

Re: Miele 3164 and suds on the final rinse.

Newer machines are designed to get a better wash from less powder.
Use less powder, there is a function for extra rinse and extra water level on your machine, use it if you are not happy.
Its in the instruction manual how to set extra water level as far as i’m aware.

[Seamy]

Re: Electrolux EOG6000X Won’t turn off! – Temperature Knob I

You need to get a Gas Safe registered engineer to look at it, no-one on here can give any information to you, see rules of forum.

[Seamy]

Re: Belling XOU176SS thermostat

Whats the 44444???? product number?

[Seamy]

Re: beko wmi71641 not pumping out

You can easilly make up a test lead, a cable with plug at one end & two crimped on amp tag connectors (insulated) suitable to push onto pump. Run pump on test carefully to prove its not sticking in housing for instance. Likely the triac that drives the pump has gone on the board because the pump overheated at some stage. Best news is the parts are cheap.

[Seamy]

Re: Fault code E50

Its an older type FHP motor I presume, part number 1320799016 fitted to these. As my learned friend previously posted its most likely the brushes are worn, or getting bad contact because of too much carbon on armature.

[Author]

Posts