Seamy

Forum Replies Created

Viewing 15 posts - 871 through 885 (of 2,653 total)
  • Author
    Posts
  • in reply to: Miele W504 heater element #401891
    Seamy
    Participant

    Re: Miele W504 heater element

    Amazing that they don’t leak very much when you consider its just a push fit, every other appliance needs a right spannering to get them leak free.

    in reply to: Beko CG960 problem advice please #401650
    Seamy
    Participant

    Re: Beko CG960 problem advice please

    Sounds lik it may be low on gas.
    May not be economical to get it done again though, the fact that its gone low on gas points to a leak somewhere, not too easy to find a leak so a re-gas may be a pointless if its gonna leak again.

    in reply to: AEG F86050VI pnc911234726/02 s/no.33091859 #401702
    Seamy
    Participant

    Re: AEG F86050VI pnc911234726/02 s/no.33091859

    P.C.B could be at fault, they are known to have poor relays, sometimes the solder connection has dry joint. Otherwise check the fliter for blockages because poor water flow will have effect on heating or poor water fill can result in bad washing performance. Check spray arms can turn o.k too.

    in reply to: Belling Range Cooker #401231
    Seamy
    Participant

    Re: Belling Range Cooker

    This one & the one i’ve shown below would be both at the low end in price & also build quality, you get what you pay for.

    If your on a tight budget heres one, similar spec’ check size is same.

    http://www.argos.co.uk/static/Product/p … :c|adp:1o5

    in reply to: 12 flashes #401513
    Seamy
    Participant

    Re: 12 flashes

    If its a diverter valve you mean.
    On a dishwasher i’d presume that is the valve that switches water on & off to top spray arm on half load programmes.

    in reply to: Beko DWD8650X upper arm not spinning #401301
    Seamy
    Participant

    Re: Beko DWD8650X upper arm not spinning

    Suspect that top basket is not going back far enough & not seating correctly.
    Theres a (grey) flat pipe coming up back inner of dishwasher called feed pipe, it has 2 wings/guides, if one or both of these are bent it will prevent the top basket going back far enough to locate properly & poor water feed to top spray arm.

    in reply to: leisure al6cdw #401326
    Seamy
    Participant

    Re: leisure al6cdw

    That one will do the main oven, they recommend you change the wiring and use the wiring supplied in the kit.

    in reply to: Competence D8800 -4 M #401345
    Seamy
    Participant

    Re: Competence D8800 -4 M

    There are several elements in this product, suspect one of them is faulty.

    in reply to: Moved house – help needed! #401489
    Seamy
    Participant
    in reply to: Zanussi zwd16270w1 e73 #401486
    Seamy
    Participant

    Re: Zanussi zwd16270w1 e73

    As with any faults on a washer dryer, first thing to check is the heater for earth leakage.
    Check NTC at bottom in rubber concertina hose & theres another one in ducting at front/top which goes down to door bellow.
    Pinch/tighten the plug/leads going to them as they sometimes get tarnished/green corroded connections, normally once they’re cleaned off they’re o.k.
    Furher back/smaller of the 2 P.C.Bs is the dryer one.

    in reply to: Miele w1514. #401111
    Seamy
    Participant

    Re: Miele w1514.

    And that lug/lip fitted on the top of door boot/gaskets on most machines is an anti-splash device, supposedly !

    in reply to: she 72630 update starts & then stops immediately #400958
    Seamy
    Participant

    Re: she 72630 update starts & then stops immediately

    When “she” flashes, can you count the flashes & report back.

    in reply to: Beko DC5422 cooker #401165
    Seamy
    Participant

    Re: Beko DC5422 cooker

    Think its a 2 gang selector switch with t’stat piggy backed behind it.

    in reply to: Zanussi ZWF 1021 #400536
    Seamy
    Participant

    Re: Zanussi ZWF 1021

    New interlock required, some of them take an age to cool off

    in reply to: AEG Electrolux E9 cooker fault D98000VF 948522155 Ceramic #400523
    Seamy
    Participant

    Re: AEG Electrolux E9 cooker fault D98000VF 948522155 Cerami

    As I said I had the same fault, but plug was in wrong position, when moved over one tag position it worked perfect, no E9

Viewing 15 posts - 871 through 885 (of 2,653 total)