Forum Replies Created
-
Posts
-
Re: beko WDR7543121 wont power up
Check dryer element is’nt low to ground, this can affect electronics, otherwise change the P.C.B.
Re: Beko WMB91243 Washer Module
If tracks were blown on DC module you would have no motor action.
Main board would normally be at fault for the problem described, the tacho coil on motor needs to be checked also just in case.Re: lamona dishwasher wiring
Loom complete should’nt be to dear, easy job to fit one, have done a few of them.
Re: Lamona (Beko?) Dishwasher 13-514356-07
Model num’ would be more help, that’s a ser’ num’ you’ve posted
Re: Belling DW no heat
Thermister faulty perhaps, depending on which IDW604 it is, one had sensors on door 2 ‘stats & an NTC as far as I remember, on another belling dishwasher there was a switch on a hose between wash pump & heater, if not enough water pressure was achieved it wouldn’t heat.
Re: manually override aquasmart water level
Would advise against over-riding level controls…
appliance make and model may be a help for anyone offering help though
Re: Beko wm6355w
F11 + Motor Tacho short circuit, check tacho coil change if necessary, if that doesn’t rsolve its maybe a faulty p.c.b. Hard to diagnose without testing the appliance components.
Re: Miele W3740 Not happy
Sounds like anti-crease is selected, as far as extra 20 seconds at beginning of wash, they mostly have a water divertor motor on the back top of the soap dispenser, this searches for the correct position, first before directing the water into selected section of soap drawer. If it does’nt find position it may go around a few times until switch for correct position is made.
Re: Beko Washing Machine WDX8543130 Fault
Yep, have had this problem with this particular appliance, it could be the motor but that has a 10 year warranty as far as I know, it could be the ProSmart invertor board or control board. I’d advise you to get an engineer to test the components mentioned to establish which is giving the problem.
On the ones i’ve worked its been the inverter board that was faulty.Re: Stoves Richmond 444445378
door switch, selector switch wafer blown perhaps?
on any cooker/oven you can trace the wire back to see if it goes through door switch, cut-out, contact of selector switch etcRe: Beko wmb91442L
If you are sure its motor related, i’d start by replacing the inductor first its the cheapest bit of motor circuit, but its difficult to diagnose without being able to test the product, the 3 phase motor can be tested by a meter to check the circuit is ok or not.
Re: aeg washer
Would there be an aqua control inlet solenoid on the incoming pipe of that integrated machine by any chance?
Remember having to fit an inlet valve onto an integrated one like this a year ago which cured this E10 problem that it had.Could be intermittently going open circuit on either coil of valve.
Of course it could be the pipe going to pressure switch off the pressure switch, clogged pressure switch hose, clogged pressure vessel etcRe: Interior Light Flashing
kwatt wrote:The LED unit will be faulty I expect, it’s this one:
http://shop.ukwhitegoods.co.uk/49020109 … t-assembly
I don’t know what the score is but I don’t think they’re covered by the warranty being a bulb.
K.
When is a bulb not a bulb?
When its a circuit board, with L.E.D’s
