Forum Replies Created
-
Posts
-
Re: Dyson hoover DC02 cutting out (ten years old)
the TOC is available as a seperate part, p/n 00392-01
Re: Maytag LAT9306GGE top loader
If its the tub bearing that needs replacing ( the rubber mount one on the underside of the outer tub) the tub will have to be removed.
The inner drum will have to come out first.
Remove the adgitater to expose the mount stem and nut.
To remove the mount stem and tub nut (l/h thread) you will find almost impossible if you dont have the special spanner.
Once both tub and drum are out it should be fairly obvious
Dont forget to fit a mount stem kit as well
HTH
Re: Electrolux W355H
Have a look at this
http://www.laundrysystems.electrolux.co.uk/node324.aspRe: pat test help
I’ve seen domestic w/m’s hard wired, with a switch above the worktop, (as no dought you all have ) but I still test it for insulation.
All appliances should be tested, with or without a plug.
If without one, then test it from the terminal block.
It covers your own back, if nothing else.
Re: Bosch SRS43C12 pathetic spray
bobokines wrote:
I did notice that there is a tacho feedback on the motor. Anyone any idea what that’s for?
Bob
A lot of Zanussi D/W use a tacho for ‘variable speeds of rotation’ (as in TDS) so presumably Neff is similar
Re: ANY COMERCIAL ENGINEERS
For spares or service the distributors are Anglowest, 1 carlisle Rd, NW9. 02082057285
Re: You’ve just got to laugh
Martin wrote: and charge an extra £5 every time I’m asked to show my ID Card 😆
Yes I’ve got to laugh.
No cup of tea = add £5
Child crying, or dog barking = add £5
Dirty or smelly house = add £10
Cut hand = add £5
Georgeus housewife = minus £5Re: Compressor Alternative
Does any one use the Lokring system when fitting compressors?. Is it easy to use? Is it cost effective? I have been told not to braze connections on R134a systems, as it is potentcialy explosive.
Re: Beko DC3511 SI electric cooker Thermal Fuse
Have a look at this
http://www.ukwhitegoods.co.uk/modules.p … ic&t=31689Re: Hotpoint VTD00 strange fault description
check that the knobs not broken where it pushes on the shaft
Re: Hotpoint WMA Door Seal Clamp
Thanks for all the replies. The idea of using washing up liquid sounds a good un.
However, the seal I used ( a genuine Hotpoint one ) was covered in some sort of mineral oil, maybe to assist fitting.
Re: Where Can I Get Atag Cooker Hob Spares?
The 4atag link looks suspiciously like connect
