Forum Replies Created
-
Posts
-
Re: Bosch fridge freezer – ENr KGV3 120GB/01
It appears that this model has non-replacable foamed in NTC sensors, will confirm tomorrow when I have access to my Quickfinder technical laptop
Re: Philco DW1906
Might sound obvious but have you checked salt cap lid for cracks or perished seal ❓ , These can cause salt to leak in throughout cycle leaving a salty coating on the crockery ❗
Re: UNKOWN INTIGRATED FRIDGE/FREEZER
Thanks for info Dave, customer cried off for today, caling next week, at least I now have all the info.
Sparkey
Re: UNKOWN INTIGRATED FRIDGE/FREEZER
Thanks Dave,
Customer say’s she cannot find any manufacturers name any where on the appliance, she has even got to the extent of removing the wooden doore to see if anything was printed on the front ❗
I’ll check the thread before I call and see her tomorrow pm.
Regards
SparkeyRe: Hygena Dishwasher user manual
Some models have rating plate on rear of machine on lower cover plate
Re: Homark 02-800101
Dave wrote
Ok Thanks. Is it a Brandt made cooker do you know
Not sure about that, as it’s only listed in old paper lists it’s quite an old model
Any idea of the phone number ?
0870 750 2435
Re: New Moderators
kwatt wrote
You may have noticed that Martin has been added as a moderator
For those of us unfamilular with the workings of this new fangled internet thingy what does a ‘moderator ‘ do ?
Re: Homark 02-800101
Dave, the number listed in the old ‘paper parts sheets’ is C72-0074-0
I’ve also asked EAC but have had no response.
This is due to the ‘new improved service’ 😥
If you ring Bernstein they will sell you parts, pay up front by credit card no trade discount even to old agents they have dumped on 👿
Re: “Cookers” – supplied by Bernstein Group PLC
wet wall blown wrote
From what i can gather us at” Expert apliance care”
Yes you are correct wet wall, Expert do do some Bernstein work, spare parts are a problem though Three to Four weeks to supply parts is not acceptable to most engineers or customers
Re: Homark Cooker – no instruction book
burned cakes are happening!
If cakes are burning it’s probably faulty thermostat causing oven to overheat 😥
Model number will still be required pleaseRe: Installing New Bearings and Shaft Seal to Spanish Bosch
Martin wrote
Bosch Part No: 036071 Cost around £3 available
Sorry Martin that part number is for thermostat sender seal on models where the sender fits at front of tub under the weight.
Bosch “quickfinder” does not list seperate seal or bearings for these spanish made models only the bearing cross complete.
Re: Hotpoint Advertise Franchises!
Don’t hold back technics 👿 sounds like “been there done that got the teeshirt ❓
Re: Hotpoint Advertise Franchises!
So the area widens, anyone else seen the ad anywhere ?
Different add in East Anglia Region, Hotpoint/Indesit advertising for direct employed engineers
“electrical skills £17,402 – £20,891”
“gas skills £19,108 – £21,460“Our benefits package includes”
25 days holiday (plus up to five extra for good attendence)
final salary pension scheme
free life insurance
profit share
van available for private useapply Merloni Peterborough etc
Re: Waste Disposal Unit – ‘In sink erator – Model 55.1’
IN-SINK-ERATOR service & spares department
Aquatherm The Mill Stortford Road Hatfield Heath Herts CM22 7DL
Tel. 01279 730018 Fax 01279 739009
If your problem is water leaking into motor unit and unit is over two years old bin it and buy new applianceRe: Pin hole in stainless steel
Streetlighter wrote
The problem is what is the best way to seal a pin hole leak in the base of a dishwasher
BSH Appliance Care do a low temperature for this repair, involves no stripping out solder from inside tank. No part number available for this item, talk to their tech. department.
