[sparkey]

Re: ASKO SPARES

Connect are the UK distributor for the “real” Asko spares

Thanks for that Dave, I don’t have an account with them as I specialise in BSH repairs.

This is a ‘family’ repair 😥 , do you have access to them if so how much is the outer door frame?

Regards
Sparkey

[sparkey]

Re: Bosch KGU3201GB E2 problem

TKE wrote

Thanks very much to Sparkey and BSH-Man

Glad to help.

Regards
Sparkey

[sparkey]

Re: Bosch KGU3201GB E2 problem

emsee_uk wrote

Bosch experts confirm this substitute PCB will take care of the E2 error i’m getting so i don’t need to replace the faulty evaporator thermistor?

Yes emsee the panel 263782 will take care of the ‘E2’ fault 😀 ,.
you cannot replace the evaporator sensor it is not available as a spare part and is buried in the foam insulation.

Regards
Sparkey

[sparkey]

Re: Neff GB1051 D/O

anyone know if the M/O hinges and females are still available?

Enr No. Please Clive, should still be available.

Regards
Sparkey

[sparkey]

Re: SIEMENS HB76220GB/01 FD: 7105 grill

iantow wrote

checked the part number of the grill element, and said that it was unobtainable.

have just checked on http://www.bshappliancecare.co.uk grill element still listed part no. 282790 £72.85 inc vat

Regards
Sparkey

[sparkey]

Re: Bosch T/Dryer light bulb ?

Is the light bulb change a simple matter

On some models the lens cover is a simple push fit into the body on three legs, prise it out with small screwdriver, if it’s been well used may be good idea to have new lens available, they do get brittle after a time and the legs snap off

Regards
Sparkey

[sparkey]

Re: Bosch KGV3120GB/01 compressor wont run

Simon, You will not hear any thing from her you have done a successful repair 😀 , works every time IF the sensors are at fault.

Regards
Sparkey

[sparkey]

Re: Problem with Bosch fridge freezer KGV3120GB/01

The most likely fault is the failure of one of the foamed in sensors, replacement is not posible but there is a service resolution that can be done by an engineer, (not a diy repair) suggest you click on the big red tool box (repairs@) to find an independent engineer in your area to help you.

Regards
Sparkey

[sparkey]

Re: Bosch KGV3120GB/01 compressor wont run

On four pin edge connector DO NOT TOUCH WIRES ON PIN 2 & 4 only cut the sensor two core lead connected to to terminals 1 and 3 leaving about two inches (old money) 😉 connected to the pins, join them together, job done.

Compressor should run straight away when plugged back in, if it does’nt and you have followed my instructions as above then the fault is not with the sensors, have you checked for power at the compressor? may be blown relay/cutout.

Regards
Sparkey

[sparkey]

Re: Bosch KGU3201GB E2 problem

How can I tell?

KGU3201GB/01 has operating panel inside front facia and flat power board that slots into top of appliance.

KGU3201GB/05 has operating panel inside front facia and power board in compressor recess near lamp transformer

Regards
Sparkey

[sparkey]

Re: Bosch KGU3201GB E2 problem

TKE wrote

My Bosch KGU3201GB fridge/freezer is displaying a flashing E2 on the fridge display

This fault code indicates a failed fridge evaporator, only cure is replacement of electronic control board in top of fridge (flat plug in one).

sensor modifications do not work on this model

Please post full Enr No. or refer to http://www.bsh.co.uk for price of board. is expensive 😥 if you have any doubts click on the big red tool box to find an independent engineer in your area 😉

Regards
Sparkey

[sparkey]

Re: Corgi cowboys?

Kwatt wrote

You as a private individual can take your gas boiler off the wall if it breaks. Pop down to B&Q, buy a new one off the shelf with no proof of competence required. Take it home and fit it and not a soul can say “boo” to you about it!

Are you sure about this ❓ I have in the past had experiance of gas installations and plumbing and am in the situation of installing the plumbing side of central heating at home at the moment but have been told that boiler manufacturers require evidence of Corgi instalation before they will honour guarantee in the event of failure. Perhaps things are a bit different ‘over the border’ ❓

Regards Sparkey

[sparkey]

Re: Bosch Dryer WTA3003GB/17 Drive Belt broken

JennyV wrote

will be back on 11th April to fit belt!

Just a suggestion but have you tried “repairs@” ( the big red toolbox) on this site.
You may find an independant Bosch service agent in your area who can help quicker. I carry that belt as van stock but unfortunately do not cover your area.

Regards
Sparkey

[sparkey]

Re: Technical specifications of fridge Bosch KGV

E-NR KGV 2601-02
F.D. 7303

This model was produced in March 1993 so I doubt if there will be much information available now.

Regards
Sparkey

[sparkey]

Re: bosch f/f E2 error dode

can anyone please tell me what an E2 error dode n bosch KGE3301GB

Hello jonggriffin,

yes the fault code E2 is failure of foamed in sensor. On this model you cannot short it out 😥 , the electronic panel has to be replaced price for part & order bshappliancecare.co.uk have full Enr number available 😉

Regards
Sparkey

[Author]

Posts