[suedehead1]

Re: Neff T1872NO/01 hob.

thanks for the reply, just as i thought whoever installed it has not left access to the underside, the hotplate required is listed at £170 so that should be enough to put them off.

[suedehead1]

Re: Neff T1872NO/01 hob.

raising an old thread, i went to one of these today and one of the hotplates isnt working the botttom of the hob cannot be removed because of bad installation, and the hob is stuck to the worktop with sealant, anyone got any ideas how it can be repaired please.

[suedehead1]

Re: Spam

more of the same

[suedehead1]

Re: WF541 F01 error, Fixable?

motor triac faulty
check motor , wiring and connections, could be a broken wire at the motor plug.

[suedehead1]

Re: Hoover Logic 1200 A3786

put the powder in the left compartment or put it straight into the drum on top of the clothes.

[suedehead1]

Re: Indesit WIXE127

pressure switch or pcb?

[suedehead1]

Re: Bosch Tabletop Dishwasher Manual (SKT5002?)

prog 1 is 65 degrees as is program 2, program 3 is 30 degrees.

[suedehead1]

Re: Hoover Logic 1200 A3786

the left hand side of the cold water valve is not operating properly, fit a new valve , or swap the wires over on the 2 cold valve solenoids and swap the black hoses going to the back of the soap dispenser this will make it fill ok on wash but will not help it taking the fabric softner,

[suedehead1]

Re: hotpoint 9506 replacing a door seal

yes, no, yes.
plug out.

[suedehead1]

Re: Hoover Logic 1200 A3786

no repressurisation. the machinewont tumble unless it has enough water in it, as tim said the humming noise is the water valves, the hoses are kinked, the taps are not on fully or you have put the hot and cold hoses round the wrong way.

[suedehead1]

Re: Hoover Logic 1200 A3786

have you kinked the fill hose or is the water not turned back on fully.

[suedehead1]

Re: Hoover Logic 1200 A3786

there isnt supposed to be any silicone sealant there should be a hole about 1/4 inch diameter that stuff is probably hardened soap and will almost certainly be causing the problem.
the belt going is a coincidence, if you are replacing the belt make sure you note where the couloured wires go to the thermostats.

[suedehead1]

Re: siemens se25m830gb/07 dishwasher pump

tanks martin i didnt realise that siemens parts were on there as well the model was an sn25m830gb/07,the pump for future reference is 611332.

[suedehead1]

Re: Candy Washer CMD136 blown module

i had one where the wires going to the water valve were rubbing on the dryer, i sent the pcb to emw and got it repaired, the mormally tell you to check something if its an obvious fault.

[suedehead1]

Re: Hoover Logic 1200 A3786

its the plastic “bottle” type thing at the botom of the backplate, if its blocked the machine doesnt know wether there is water in it or not, if its blocked it wont spin even if its empty.

[Author]

Posts