[suedehead1]

Re: electra awm1100b eco has power/water but does nothing

that sounds right tim i thought it was one of the older machines with the 8 tags on the bottom but its more likely the usual servis door locks but nothing else pcb fault.

[suedehead1]

Re: Servis M6015 will not always spin and does not fill now

printed circuit board , module,
take the plug out of the socket before checing.

[suedehead1]

Re: electra awm1100b eco has power/water but does nothing

its a servis i think it will be the door lock.

[suedehead1]

Re: electra awm1100b eco has power/water but does nothing

a picture of the washing machine would be better.if it has no brushes and a v belt it is either a servis or a whirlpool the door lock might be faulty i dont know any way of checking it without replacing it.

[suedehead1]

Re: Servis M6015 will not always spin and does not fill now

pcb plug out if checking.

[suedehead1]

Re: neff s5543x1 dishwasher

i checked the valve and it was ok.

[suedehead1]

Re: diplomat HJA8630 dishwasher

thanks to everyone who helped me out with this one i forgot to get back and let you know that i fitted the flow meter and it worked perfectly.
for all the cod]st of the flowmeter it is worth trying a new one on anyway,
thanks again.

[suedehead1]

Re: servis module

emw dont fix them i asked tony i have a janus device so i could program them.

[suedehead1]

Re: diplomat HJA8630 dishwasher

sorry i got lost when it all went a bit technical.

[suedehead1]

Re: Help needed with Whirlpool Washing Machine.

the concrete weight breaks because the bolts loosen off, i would check the fixing brackets where the bolts go, if they are damaged the machine is not worth fixing, the concrete weight and bolts are available as spare parts.

[suedehead1]

Re: diplomat HJA8630 dishwasher

has anybody got the part number for the flow meter on this machine i cant seem to get it anywhere.
thanks.

[suedehead1]

Re: whirlpool adg642

i have checked the wiring and visibly checked the pcb i suspect a relay has suck on it.

[suedehead1]

Re: whirlpool adg642

fitted a new ntc id didnt fix it i have also wired up another motor,pump pressure switch but it still flashes the light and the pump pulses which i also changed any ideas?

[suedehead1]

Re: Hoover AL130

you cant change the bearings with the drum in.

[suedehead1]

Re: Scraping the barrel

as far as i can remember the pumps were plastic the wash pump had a flat plastic pulley which ran on the outer edge of a v belt still available from connect, the spin drain pump had a aluminiun pulley which took a thin round elasticated belt i have one of each kicking about somewhere.

[Author]

Posts