Forum Replies Created
-
Posts
-
Re: Hotpoint WMA11 – I just cant pin this down??
have you checked the wiring goig to the motor they can get rubbed against the concrete weight and will blow tracks.
Re: hotpoint aqualtis
is the ribbon cable a spare part on its own or does it come with the door i have just got a fax in with parts diagram and the cable is not listed
Re: hvr ca231
dopper wrote:, sits full off water door locked,
,
there isnt any buttons pressed in i was at one which had a “caress” button, i didnt know what it did but seemingly if it was in the machine stopped full of water with the door locked.
failing that the slave timer is a good bet.Re: hoover six 1200 wdm 120 01 door latch electrics
nowdenhowden wrote:hello,
engineer came, took old faulty doorlatch off and never showed up again.
!
why do you put up with that ? you should have used an engineer off of repairs@
forum rules dont allow but i would be surprised if someone doesnt give you a clue.
i cant remember off the top of my head but i might post tommorow with a wee clue myself,
i hate to hear stories of engineers disapearing with parts and not returning.
if people let these guys away with this sort of thing they will keep doing it and give the rest of us a bad name, rant over.Re: Hoover HNF3147 bearing change
i would advise if it is less than 5 years old get hoover to fix it under their 5 year parts guarantee.
i wouldnt say it was a DIY job.Re: bosch tabletop dishwasher flood.
i have the hotpoint version myself and it would periodically leak, i found out if the water pressure was too high it would leak out of a plastic bottle type thing at the right hand side its a real pain to work on.
Re: wma motors
i tried to do the same thing before but i found the wires in the motor connector block were not the same for the different motors.
Re: hoover ca233uk
i would check the heater or the thermistor or the yellow wires going to the thermistor.
Re: Indesit DI620 dishwasher
hi,
i fitted the old board then refitted the new board followed leaflet exactly and it worked.
customer phoned me to say it has gone throegh 2 loads and is working ok.
thanks very much.Re: Hotpoint Interlock Warning
i think this was a good thread to start, i have put a new white interlock on replacing the old red one, you used to get a leaflet telling you to cut off a lug but they dont do that now.
if i try hard enough i can put the plug in the wrong way round and i have always wondered if it would blow the module as they are so sensitive.
