Forum Replies Created
-
Posts
-
Re: Neff fan oven elements
to what? had some last week still on that part number
499003, just had some new van stock ones through 😉
Re: Bosch KSV2422GB/01 light switch
The cam can be teased out using a terminal driver, dont be too brutal though as it can snap :lesson: .
you can then fish out the actuator (066888) probably find it’s bent, youcan then either bend it back into shape or replace, I usually just bend them and apply some silicone grease.
Re: bosch maxx wil 2260 problem
Remove soap drawer, look for the four small holes above the conditioner compartment.
More than likely you will notice the holes are blocked with black gunk!
Find a small cable tie and poke it into the four holes giving it a good wiggle 😳 . Then turn to a rinse program and flush through, may need to do this a few times.
Re: Animal damage
Had a sump hose yesterday that had been chewed by a mouse.
And a float that had been attacked a few weeks back.
Re: Sluggish Fan on Neff Oven
Yup needs a new fan motor part no. 096825
No fitting instructions though. If you’re not sure best call an engineer.
Power off first if you have a go.
Re: Bosch KIV3235GB/42
they will get revenge one day!
Not with the current muppett in charge, lets hope he gets Svens job 😆
Re: Bosch WTR6103GB tumble dryer
I assume you mean WTL6103 as there is no WTR 😉
I believe cupboard dry is overheat fault.
Changing ntc at front and heater unit should cure fault.
Just make sure filter and condenser are clear first. Also run filter under tap and make sure it doesn’t hold water. Have had a few like that.
HTH
Re: Neff S5555 Solenoid Valve Noise
More than likely the way the water pipes are.
What is known as water hammer.
Not sure if there is anything you can do about it. 😥
Re: Bosch KKU3301GB/05 BLOCKAGE INTERNALLY IN SYSTEM ??
Freezing in fridge is usually a sticking diverter valve.
To repair would involve breaking into the system. Not the cheapest repair in the world I’m afraid 😥
Re: Bosch SGS43A32GB/01 dishwasher/floorwasher!!!
You guys are fitting the revised overfill mushroom aswell as the new pcb aren’t you ❓
Sorry but new part no. escapes me at the moment 😳
