[timdowning]

Re: Samsung B1245S Wash M/c Door Handle – Supplier Please

Give GBDAR a call 01942 601 604.

[timdowning]

Re: DHL collections

Thanks for reply,

I will hold fire and try and squeeze another waste machine in my multi-use garage.

🙂

Cheers,

Tim.

[timdowning]

Re: Servis washer Heater – M3025W – 20030406632 – 020077177

heater part number: 524018700

[timdowning]

Re: Hoover WDM 120-01 dryer timer?

Are you sure the dryer timer knob hasn’t slipped out of allignment?

Also this type of machine always carries on the tumbling phase for a good 5 minutes even when the dryer timer has reached zero minutes.

the customer may be assuming its still heating?

[timdowning]

Re: HPT WF 860 error/test

Board fault if heater,wiring,ntc ok.

[timdowning]

Re: baumatic/servis no spin tried module

check heater for low insulation.

[timdowning]

Re: LG WM1480FHD

cheers. do you have to have an account to order as trade?

[timdowning]

Re: Creda dryer getting too hot?

you probably fixed it too well! can’t please some customers!

I doubt theres a problem as stat would trip again.

[timdowning]

Re: Hoover ca232.uk

check for earth problems, check for blockages, check for syphoning, check pump hasn’t been leaked onto. if alls well 9/10 its the timer/selector. part number 91201337.
1/10 the main module.

[timdowning]

Re: repairs@ do you get many?

exactly the same as you.

[timdowning]

Re: bearings baumatic wd12

Baumatic contacts for you;

Spares:
0118 9336 922

Technical advice:
0118 9336 933

[timdowning]

Re: wfr3267gb/04 fd8308700251

cheers

[timdowning]

Re: Hoover HNC 170 Heater Change?

I can’t see a problem with inline splicing these heaters. hotpoint supplied connectors with their thermostat kits.

Drum out job is not so bad. (drums are better than they were.) While you’ve got the drum out lubricate pulleys and rear bearing as this will save a re-call when customer phones with squeaking machine.

Heater change and full strip down can be done in an 1 -1.5 hours.

[timdowning]

Re: Hoover HNC 170 Heater Change?

On the condenser models they sometimes prevent you from getting enough slack on the wires to disconnect the heater. I had a tc50 last week where i could just manage it. On another condenser dryer i cut and inline spliced the wires and protected with the heat resistant sleeve.

I thought this was easier than a drum out job.

[timdowning]

Re: wfr3267gb/04 fd8308700251

whats the “motor pcb” for at the bottom front of the machine if the motor plugs directly into the operating module??

[Author]

Posts