Forum Replies Created
-
Posts
-
Re: Creda T522VW
Thanks for reply. Do you have the part number for the plastic door lock cover. The part that the sits on the shell of the machine in front of door lock.
Re: servis m6002 going into spin
Yes it is the board at fault. Insulation test the motor while you are at it. If motor ok just change the board.
(Had the same fault last week on the same model)
Re: Bosch WFO2855GB/01 no spin.
See my post on the following date, it may help.
Wed Jun 06, 2007 7:01 pm
(Sorry don’t know how you link directly to it.)
[/list]
Re: Hoover WDM130-01
You can normally seen the bad solder point on the PCB. Give it a clean up and a blob of solder. (usually does the trick.)
Re: WD420
Cheers.
Is that part number correct? or is it Connects picture thats wrong? Connect show the timer knob.
Re: HOOVER AL110 – Airlock ???
I have seen this loads of times with this type/model. The fact that the machine does eventually pump out is fine. I assume the original fault was no drainage at all? I have never fitted a like for like pump on this model, i only change the pump end with a universal Askoll. I have never worked out why it ‘hangs’ on letting the water out but it does.
Did you fit a complete genuine pump?
Re: Is the failure rate still low?
Good News. I’m still battling to convince people that the ISE is worth the ‘extra’ initial outlay. This feedback only strengthens my sales patter!
Cheers.
Re: hoover h110m( no power)
Is there power to the suppressor?
Is the pump open circuit?
Is the door hook loose inside door assembly? (therefore not making interlock slide effectively)Re: decisions decisions
I’m half your age and wouldn’t dream of expanding from a one man band set-up.
I would say stay as you are and retire gracefully!!!
😀
Re: candy fridge/freezer
Good question. To be truthful i don’t know. The information i have is third hand originating from my 92 year old nan.
Could you give me a flow of things to check?
Re: Hoover HPB145 Washing Machine
If it dosen’t reset by just turning it to OFF. Then hold down start button for 5 seconds.
