Forum Replies Created
-
Posts
-
Re: AEG 40010 VI
Cheers Seamy, the sump with bonded hoses is what Ive got. Do you know of the newer style sump where the hose is clamped both ends rather than one end being bonded. Im really reluctant to change a sump on this model when all i need is a hose. Thanks.
Re: One man delivery, top flat, no problem!
82.6 Kilos, He needs to get his scales calibrated. More like 70 kilos with everything in it. For a start he’s taken the valves, drain pipe & mains cable off. I bet the motor and concrete wasn’t in there either. Cheating….
Re: Hoover VHD8122-80 fault
All I know is she’s doing alot of washing. 3 washes on the bounce! I’m sure she’s making it up, never heard of such a fault. Barge pole time…
Re: Bosch WFL22066GB/08 No heat
Not much else in the circuit really. It could be just a bad solder point. The boards are a bit of a fiddle to get apart but may be worth a try.
Re: Hotpoint WML540 & WF561 door seal problems
Fingers crossed the heater dosen’t go open circuit as well.
Re: QUALTEX BOSCH PUMP
A few pounds? £28 difference between pattern & genuine.
I know I’m a bit of a miser but…Re: John Lewis JLWD1404 Washer No Dry
Not wanting to state something you may already know?
But the fan and heater don’t operate on this range for a good 5 minutes. Did you leave it long enough?
Re: 1607w rubber lip thing around door
The last one I delivered & installed had exactly the same bow in the panel. It looked so uniform I thought it was meant to be there. I will keep your post in mind!
Re: Hotpoint WDL520P all option lights flashing
I cant give you a definite answer to what it wrong, but on these strange faults I would check every part electrically for resistance & insulation. If all connectors have been pinched / tightened then I would look to see if EMW do the boards on this model. (It is always worth paying attention to motor connections as well as door interlock connections).
