Forum Replies Created
-
Posts
-
Re: indesit semi integrated dishwasher
I think this is the correct data –
LED 1 & 3 Pressure Switch
The machine has filled with 2.5 litres of water but the pressure switch is still in the
empty position.
• Check the filter or sump is not blocked.
• Check the pressure switch is not stuck in the empty position (contacts 11-12) or the
pressure chamber or air tube are either blocked, unattached or split.
• Check the wash pump is circulating the water.
• Check the wiring to the pressure switch.
• Check the edge connector blocks on the pressure switch and module card.
• Check the outlet hose is not too low causing the machine to siphon.
• Aborts the cycle and energises the drain pump.Re: Bosch WVD24520GB/08
I know the motor going out of circuit causes the display to go blank, so a check of the motor connector & brushes may be worth while.
Also plugging the machine into another socket for a few goes just to eliminate a weird socket fault…Re: ideas for red spot aeg/zanussi dryer stat on element
If you carefully prise off the stat you can fit an appropriately rated stat from a hotpoint kit.
If you ‘wing’ out the terminals, as you screw
the heater back in place the tension caused by winging out against the metal of the dryer holds them tightly into the heater.Re: Wet vac washing machine emptying
Sounds a bit fiddly.
Through the drawer,through the dispenser hose,
through a narrow gap pass the drum then to the water level…Re: Wet vac washing machine emptying
I wouldn’t survive without a wet vac.
It saves so much hassle & time.
I leave mine running longer than needed too just to
stop me having to talk to the customer!!
