Forum Replies Created
-
Posts
-
Re: Zan jetsystem 1400 FJR1454W pump 5 secs > St/pse flas
Carbon deposit on board creating an un-wanted circuit?
Re: Hotpoint DF62
Drain off water & dry as best you can.
Clean matrix / tube.Then with the sides still off give it a whirl & watch.
You may find it dosen’t leak & was due to tablet (doubling up on rinse aid) used or customer opening door during cycle.
Re: Zanussi washing machine ZWF1240W E30 error code
E30 is pressure switch related. But do check insulation of motor & heater. Low insulation can cause this error.
Re: Hotpoint WD63 problem
Resound and Rayovac
Who are they, a 60’s rock n roll band that you listened to too loud?
❓
Re: Hotpoint Aquarius FDW60 – Fault.. please help 🙁
poof of smoke
Thats not good.
No-one wants that in their kitchen.
Re: Hotpoint WD63 problem
How about the pressure switch?
As you know the last rinse is higher than the wash and other rinse level.
Sound like its going into the safety level of the pressure switch?Saying that ive never changed a p.switch on this model and am only assuming it has afore mentioned safety level.
What do you reckon?
Re: ISE10 v Dyson CR01
not sure if im going to the meeting yet?
im in bedfordshire, i could always get it to brians of ffr if thats of any use?
apparently hes local to me?
let me know what you think.Re: HT WMA62 door lock will not lock
Definitely the board.
Thats assuming you have used your terminal screwdriver to slide across the door lock. This eliminates the door handle / hook / spring from being your culprit. They can sometimes look & feel ok!
79.9 Mohms on the motor. Thats ok.
(You have checked child lock isn’t activated?)
Re: kitchons
I wondered where they had gone….when I google my area they are normally up there at the top.
It would be interesting to know what went wrong.
I wonder if it was finding engineers to cover the 6am time slots?
Re: AW23 soap hose
Yesterday I went to a 15 month old AW23 to change the start button & board.
Not a massive clearance but nowhere as close as yours Jim. I wonder if the suspension is being manufactured by another supplier or something?
A heavier or oversized top weight may be the easiest solution?
❓
Re: Ear worms.
I don’t think its bosch’s fault. Its the date…16th June. I was due a credit on that date from a different company. It never happened.
Perhaps this is the beginning of the end!
