Forum Replies Created
-
Posts
-
Re: Hotpoint BWD129
Update;
Cleaned & tightened connectors from control pots to front board.
Customer rang to say all is well.
Re: tvf760 dryer
I’ve not seen this model before, so was just guessing really.
What does the temperature safety on these newer models?
Re: tvf760 dryer
When you say it meters ok, is that the thermostats? As an open circuit stat can give you this fault.
Re: Whirlpool AWG5122 w/m control board
You’ve got the manufacturer staring you in the face. 😉
Its made by VESTEL.
You could get onto shop@ on this site. As some ISE machines were made
by VESTEL.
I did one of these machines on Monday. It needed a heater which was the same as the original ISE2 heater.The ISE2 or ISE5 made by VESTEL won’t have the same module though.
Re: Hotpoint WF741 Pump filter
Anyone come across this?
Yes last week in fact. Replaced filter all ok. I can’t give you the part number because I had one in my pump box from somewhere?
Must be all those WF’s I’ve scrapped recently.
I new the bits would come in handy. Recycling at its best.
Re: Hoover AS110 door interlock
This sort of lock has no delay at the end.
So it should open straight away.
The fact you had to wait three minutes would indicate not a fault with the lock but a problem elsewhere.
Did you check the pressure vessel for blockages? If thats not blocked then recheck the sump, pump & drain hose.While you are there insulation test the heater. This wouldn’t give you a door problem but can give a no spin fault.
Re: hoover hnc 7166 pausing
Or maybe its a HNL7166.
Count the number of flashes, Nextra fault codes.
Re: bosch tumble dryer
Well theres a few posts,.
Search Bosch AND dryer AND f11
Seems to be board related.
Re: servis m6135
I’m sure there was a batch of that model that had that fault. (between certain serial numbers.) Changing the module was the cure.
Was it a new module or recon ?
Re: hoover twin tub wash lid
Oh this is in a Sticky just above you.
Re: hoover twin tub wash lid
This is for a T5024;
Might do?
