[wilf]

Re: candy EVO1494L3W-47

that number is 31004166 1230-1057

thanks wilf

[wilf]

Re: Beko WMB71231W Trips RCD

sounds like a harness fault. I’ve had a couple where the wires rubbed through to the cabinet near the interlock and vibrations caused a short. no RCD makes it easier as you can see the blow mark, but in this case you’l have to look very closely

wilf

[wilf]

Re: indesit top concrete blocks securing

weight off glue around spigot weight back on glue on bolts tighten down never shift.

wilf

[wilf]

Re: ntc plugs

the plugs used are IDT type so its fiddly to remove and refix the wires with the danger of breaking the plug in the process. you only get one shot at reuse but a few spare plugs would make a simple and cheap repair.

wilf

[wilf]

Re: samsung WD8704 pump problem

have you tried putting water into the drum to reset pressure switch ?
wilf

[wilf]

Re: hoover vhw654d

just for future ref it WAS the pcb so I will watch out for this again I did try the pressure switch first but to no effect.

wilf

[wilf]

Re: BEKO DCU7230 Tumble Dryer No Heat

double check the heater ntc if it’s outside limits up or down you’ll get no heat I hook on an old hotpoint washer ntc to check.

wilf

[wilf]

Re: do you have a dead period?

not much coming in at all. just hope that I can on in for the next few years until retirement, but with the price of new so low and the modern idea of “just chuck it” I do worry.

wilf

[wilf]

Re: BEKO DCU 8230 No heating

check the ntc on the heater if its outside limits you get no heat if you have one hook an old wma heater ntc on to test it. I’ve got the resistances somewhere I ‘ll see if I can find them.

wilf

[wilf]

Re: drum lifters

have seen someone recommend pre drilling a small hole into the side of the new paddle in order to be able to insert a small screwdriver to lift the tab.

wilf

[wilf]

Re: drum lifters

any chance of that info?

wilf

[wilf]

Re: Hotpoint 9605 top loader.

talking “old” what was the one that you had to unscrew the knob cover and use a coin to reset the dial? was it 1600? long time ago.

wilf

[wilf]

Re: SIMPLE PCB REPAIR TIPS

hoover /candy dryer relay its usually the capacitor that fails 0.22 uf 250v

wilf

[wilf]

Re: Whirlpool washing machine

I have had this on a whirlpool just try hanging a spare from hotpoint or zanussi on the leads for testing before you order.

wilf

[wilf]

Re: A few minutes to spare?

raised a family by fettling stuff like that shows my age!!!!!!!!!!!

wilf

[Author]

Posts