Allsorts

Forum Replies Created

Viewing 15 posts - 136 through 150 (of 1,356 total)
  • Author
    Posts
  • in reply to: Baumatic Dishwasher & Oven……help! #418524
    Allsorts
    Participant

    Re: Baumatic Dishwasher & Oven……help!

    As for the dishwasher, doe the display come on and then go off without you touching anything?

    in reply to: Baumatic Dishwasher & Oven……help! #418523
    Allsorts
    Participant

    Re: Baumatic Dishwasher & Oven……help!

    For the Oven, you need a new fan element I suspect

    in reply to: hotpoint aquarius fdw60 flashing eco and pre lights flash #418519
    Allsorts
    Participant

    Re: hotpoint aquarius fdw60 flashing eco and pre lights fla

    Has someone leaned on the timer/delay start button?

    in reply to: Baumatic BDW13 #418517
    Allsorts
    Participant

    Re: Baumatic BDW13

    Wouldn’t be too sure of that… I could be one of many things including the likes of earth faults

    in reply to: WTA Member ID Cards #356431
    Allsorts
    Participant

    Re: WTA Member ID Cards

    Alanj wrote:Hi, any chance of getting a new ID Card? My one is getting a bit scruffy and worn. 🙁

    Alan

    Ordered .. Should be with you soon

    George 🙂

    in reply to: Bosh WFD2471 washing machine #417202
    Allsorts
    Participant

    Re: Bosh WFD2471 washing machine

    Make sure the heater is fully inserted, likewise with the sensor, then tighten the nut in the center… not too tight, but tight enough to cause a seal.

    It may be wise if the heater has displaced itself to ensure that there was no internal cause, ie a sock or similar engaged in the heater loops…

    in reply to: 070 Number scams. Warning! #417103
    Allsorts
    Participant

    Re: 070 Number scams. Warning!

    Thanks for the warning, I had no idea of the 070 never scam

    in reply to: Bosh WFD2471 washing machine #417200
    Allsorts
    Participant

    Re: Bosh WFD2471 washing machine

    Check the drum for movement. The noise, the water, and the smoke, could indicate bearing or drum-support failure

    in reply to: Surge protection? #417199
    Allsorts
    Participant

    Re: Surge protection?

    Washing machines already use line smoothing capacitors on the cable so I would not assume there is a need for such an object… your best bet is to ask an electrician.

    Having said that; even if you use one of these devices, your washing machine is still at risk to surges from any of the electrical components within should any of them go faulty… your surge protector will offer you no benefit in that situation

    Allsorts
    Participant

    Re: zanussi zwf1637 behaves for 20mins and then motor goes n

    Check the wire connections into the motor plug

    in reply to: spares for sale #416797
    Allsorts
    Participant

    Re: spares for sale

    Pushed it a bit… you should get some higher bids, otherwise I get a bargain.

    Allsorts
    Participant

    Re: Hotpoint ultima WT741 Door Error – Mid Cycle – Help need

    How far through the cycle?

    Allsorts
    Participant

    Re: Smeg Double oven -small oven ok, large oven trips electr

    Martin wrote:A thermostat either works or it doesn’t. A thermostat wouldn’t cause the RCD to trip either. And chances are on the defrost (fan only) it wouldn’t necessarily trip the RCD. In fact if it doesn’t you can be sure that it is purely an element at fault.

    Look at the first statement that the op has made “All of a sudden turning the large oven on (even just the grill, just the bottom element or even just the fan) trips the electrics.” The fan doesn’t come on with the bottom element or the grill. The only things common to all three are Thermostat (if it is the earthed type, and it is happening on all selections), Selector switch, or wiring problem.

    As for the thermostat not tripping an RCD, only did one on weds with that fault… It depends if the thermostat has an earth tag.

    The selector selects the spoken elements individually… Since it doesn’t matter which setting is selected and the RCD trips on any of 3 settings using individual elements then I do not presume that it is going to be one of your elements

    Allsorts
    Participant

    Re: Smeg Double oven -small oven ok, large oven trips electr

    Jim,

    Just checking elements with a multi-meter will not be suffice, you will need to use an insulation tester.

    What you have stated leads me to beleive that the culprit is other than the element/s that you suspect. Firstly I would be looking toward the oven thermostat and then toward the selector switch.

    For reasons of eticate and safety we are unable to instruct you on how to do this and to advise you to click here to Find An Engineer

    in reply to: Indesit IWD7145 washing machine fills but then sticks #416848
    Allsorts
    Participant

    Re: Indesit IWD7145 washing machine fills but then sticks

    Could be one of a few things, but cetainly sounds heater related

Viewing 15 posts - 136 through 150 (of 1,356 total)