[bazza500]

Re: RANGEMASTER 11O TOP

Is it gas, ceramic, solid plate or induction?

[bazza500]

Re: All checks out but no heat..!!

Have you checked the stat inside the drum above the door. It’s usually this one that goes.

[bazza500]

Re: Electrolux washer dryer ewx14450 displaying e68 fault

Test the wash element for insulation.

[bazza500]

Re: LG auto F1222D5 paddle

The advice from LG was to cut half of each fixing tab off to fit the paddle or replace the inner drum.

[bazza500]

Re: beko wmb91442lw motor problems

The Motor control pcb is inside the motor on these. Beko have been having problems with the diodes in these and the replacement motor may come with an “extension lead” but is a straight forward replacement. No point trying to take any readings through the pins as they all show open cct.

[bazza500]

Re: w/pool 3rlsq8033rwd

There is normally one inside the control panel.

[bazza500]

Re: pcb part no

4055059390. It only lists this pcb so must be configured ready to go.

[bazza500]

Re: Can an appliance made 2 years ago be considered new?

Also, your guarantee will start from your date of purchase not from when the appliance was manufactured.

[bazza500]

Re: Beko DRCS76W 3 bleebs on start button

childlock?

[bazza500]

Re: Point to Places Ltd

If you are a member of the WTA then send a PM to R600a to get them credit checked.

[bazza500]

Re: Bush Cooker Spares

Seems all the thermocouples are the same according to the diagram.

Part number 37001496 in stock at Connect. I would check this will fit the oven as it doesn’t specifically list it as “oven” in the diagram or parts list.

[bazza500]

Re: Zanussi ZWF1431S recirculation pipe

Zanussi change it to 1325112124 which is recognised by Connect

[bazza500]

Re: Re;hotpoint mistral ff72p fridge problem bypass, (Work

Well considering the thread is 6 years old removing it now would be a tad late.

[bazza500]

Re: montpellier hobs

Must say I supplied one of these hobs last week and will not be supplying another. Terminal block is too small, positioned badly and trying to get 6mm TW+E in there is a feat in itself.
Repairtech sent me half a dozen links after I complained to the DAD rep but it was days late.

The terminal blocks are ceramic so wont melt so maybe switching the hob side wires into 1 hole may have been an option.

[bazza500]

Re: BEKO WMA 765s – Pump cleared, but still cuts out after 1

Have you checked the motor brushes? If these are worn the machine will shut down as soon as it tries to turn the drum. On the spin cycle this is approx. 1 second after starting as your symptoms describe.

[Author]

Posts