Forum Replies Created
-
Posts
-
Re: How do you get a big Fridge/Freezer out?
All of the big fridge freezers we do slide out quite easily, providing they have been installed correctly!
I have been to a few houses where they have placed them on a plinth about six inch’s off the ground. :eeek:
At that point I tell them that they must, at their expense, arrange to have the thing stood on the floor, where it’s designed to be. :lesson:Another thing that gets my goat (sorry Goatboy) is the recent trend to fit integrated dishwashers a foot and a half off the ground.
I would love to introduce my foot to the groin of some of these kitchen designers 😈
Re: Bosch SGS43C12 – never ending wash cycle
Possibly water has leaked on to the base plate. Don’t go any further. Get it looked at. 😀 Follow the link below.
http://www.bshappliancecare.com/Bosch/index.htmlRe: Pay as you go
I drove 250 miles yesterday. This could prove a little expensive under this Orwellian system.
Re: Patience
Goatboy wrote:Thanks for helping my self-esteem guys!
I think BSH-man uses his powers of evil, to sense when someone types the word ‘Bosch’ into this forum. He always there like a flash.
Join the “dark side” 8)
Re: Patience
Goatboy wrote:maybe the customers don’t trust my face.
Maybe they think you’ll “fleece” them. :clown:
Sorry! 😉
Re: Cheesy residue left on cutlery and plates – help!
I’ve never rated dishwasher tablets much. Powder dissolves so much faster and it’s easier to vary the dosage. 😉
On the times when this problem has arisen, has the appliance heated to dry at the end of the cycle?Re: Bosch Motor WFF1401GB/01
It’s a good model and, if in good nick, is worth a new motor. :tup:
The end frame changes gave way to just brush change about the time of this appliance entering the market.Re: bosch f/freezer
The facia has two screws on the underside, once removed you have to prise off the facia from above using a thin screw driver.
How often does it click?
IIRC the facia module has no relays. :con:
To change the temp setting, you have to hold down the button for a couple of seconds and not stab at it with your finger. It then reverts back to the current temp until the target temp is attained.Re: BOSCH WFB 2004 BEARING REPLACEMENT
It’s a seven year old, bottom of the range washer. If you can get bearings for £25 and have the inclination then it may be a viable repair.
But I would think long and hard about spending a lot of money on this appliance at this age. :duck:
If you do go ahead then I’m sure you will get good advice from the guys on this forum.
:tup:Re: BOSCH WFB 2004 BEARING REPLACEMENT
happytadpole wrote:The drum on my Bosch WFB 2004 washing machine seem t ohave a rumbling bearing. Is replacing it a straightforward job for a mechanically competent person (which I am) or do I need special tools etc? Is it a single item or replaced in a set with other components? And the next obvious question is: where can I source a replacement?!
What’s the four digit number after FD on the lable? (on the door frame)
