[bubs]

Re: Indesit W143S Door Seal

Some of the Merloni guys use a spring but this seal just lips on, it could come off again.
I use washing-up liquid on the outside of the seal only where the band fits. Then tie the band with a small cable tie to hold, then use a bent set of pliers. Was swearing on the first one though.

Had a Servis seal i could not fit at all a few weeks ago, it was the correct part number but had to be stretched overnight to fit.

Graeme

[bubs]

Re: indesit di620 d/w

Try the rear screw on stat, had one give me intermittent heat problems last week.
Graeme

[bubs]

Re: Hotpoint WF321 Panel Lights Constantly Flicker

Cured the same problem with a recon main pcb, the guy on the phone said it was a common power supply failure.
Graeme

[bubs]

Re: Belling Format 645 thermostat

Thank you 🙂

[bubs]

Re: Bosch WFD2060GB/01 wash light flashing

Update, what i thought was a fault code was normal for this machine, so the machine was just not locking the door 😳
Took the pcb off and it was covered in carbon dust, cleaned it came back to life.
Cheers
Graeme

[bubs]

Re: Bosch WFD2060GB/01 wash light flashing

Thanks, will give it a try
Graeme

[bubs]

Re: Electrolux/Zan D/Washer – Basket runner mount

Did do the same a few years ago, can’t remember how but it was not as bad as i thought. Prob just fed in from the top.

Graeme

[bubs]

Re: Smeg D04ss-5 top oven stat

Thanks Chris

[bubs]

Re: H/Point TCM570P T/Drier – Heater Earth Fault

Did have one causing me problems, not sure if connected but found something caught in the front fan. Could be a poor flow of cool air making it condense on the back panel

All the others have been cured with the normal pump / clean out you have already done.

Cheers Graeme

[bubs]

Re: Whirlpool adp8500 odd fault

Thanks Guys, yes its similar to the whirlpool fridge pcb faults.

[bubs]

Re: belling 110 element and Smeg top oven switch

Thanks Chris

[bubs]

Re: Smeg fan motor

Thanks 🙂

[bubs]

Re: DELONGHI DFS901SS Cooker circuit diagram

Thanks, have sent you a message goose 🙂

[bubs]

Re: AEG dishwasher FAV507601D dispenser always open

Thanks for the tip, will get my meter on it.
Usually there are a few of the same type on a pcb to check against, this only has the one.

Amazing how Beko can produce a dishwasher pcb for £20 and AEG charge £100 to £200 for each of the 3 in this machine.

Have a good week
Graeme

[bubs]

Re: AEG dishwasher FAV507601D dispenser always open

Thanks Chris 🙂

Having looked at the pcb, one side of the coil is connected to the middle of the triac. The other just links down to the main pcb. I am not skilled enough to test between a device failure or a logic fault asking the dispenser to open.

May have to cut my losses here if there is no common fault.

Cheers
Graeme

[Author]

Posts