Forum Replies Created
-
Posts
-
Re: JLBIFIC02 Integrated Freezer
It’s an Electrolux as they own the AEG brand name. The element need’s checking to see if it’s open circuit and the drain tube and valve are at the back on the outside.
Re: JLBIFIC02 Integrated Freezer
If the cut-out’s have been replaced assuming they fitted the correct one’s then that really only leave’s the heating element being open circuit or the non-return valve on the drain tube is blocked causing water to back up then form an ice blockage. The circuit board or NTC’s rarely give trouble on this model and if you defrost it and it then work’s it won’t be the fan either.
Re: zanussi freezer question
If it’s not switching off then it’s defo on it’s way out and I would of thought a DV45 to be older than twenty years but if want another twenty years of trouble free then avoid buying a “frost free” model to replace it!! 😉
Re: BEKO CDA 543 FB-2 F/F FROZEN FRIDGE COMPARTMENT (PHOTOS)
If your getting excessive frosting inside the back of the fridge compartment it suggest’s a system fault which is not surprising on that model. Not worth doing anything to it.
Re: Washer Dryer – Zanussi ZWD 12270 W
Most likely the fan and it’s are belt req’d the condenser’s proberley blocked as well
Re: Britannia Bought?
wsts wrote:
captaincaveman1 wrote:
What a shame what can I recommend now??I would never have recommended them before, in their market Falcon or Rangemaster are far better products.
They were still good in relation to a lot of the cr*p we service.
Re: Zanussi Washer/Dryer ZWD1680W – no lights/power
I doub’t the pcb is at fault here It’s more likely detecting a fault and pausing the program . Could be the anologic pressure switch or heater at fault if the motor is defo ok but then how did you check the motor as shining a torch on it won’t tell you anything!. Taking circuit board’s apart and proding about will no doub’t cause you more problem’s call an engineer and save some cash in the long run.
Re: Whats the most annoying thing customers do?
Only ever been bitten by one dog in all the year’s I’ve been doing this and it was actually an old womans border collie no warning at all just came up to me and clamped its jaw on my forearm as I was leaning down to the washer the old dear nearly died on the spot and I ended up having to call her daughter to come around to calm her down!!
Re: Flavel Milano 100 (ml10frsp)
Yes its now supplied as a thermal cut out stat and not a thermal fuse so the kit you describe would be correct.
Re: Leisure DWLT 65
This is actually a Beko dishwasher so it could be the water counter at fault its located between the valve and the side tank on the left side. They are known for giving filling problems.
Re: long term powder / fab soft confusion (AEG L75480WD)
No damage will of been done just remove the drawer and clean it fully and all will be ok.
Re: Zanussi washer dryer ZWD1680W E22 fault code
I think you will off sorted the E20 fault out by clearing the condenser but I think the error stored now will now be E12 the coil on the valve as you stated if this fails then the clothes would be wet and steamy .
Re: FLE1016w Zanussi washing machine
That equate’s to E34 Pressure switch circuit fault. Normally its the anologic pressure switch at fault or pressure hose’s chaffed but can also be a PCB failure.
