Forum Replies Created
-
Posts
-
Re: zanussi built in single oven F 08 error
F08 – Communication interruption between Control unit and
power board. Check cable & connectorsRe: zan zjd1219
I think you will have to go into diagnosis to get some idea of the problem, let me have your email if you need info on this.
Colin
Re: Zanussi zk1245
The small board is the dryer board and large board would be the one to go for Pt No. 973914606103005. Have you tested the dryer heaters as any insulation fault on these can cause strange faults on these machines
Colin
Re: NEFF Semi – Integrated Dishwasher S4456N3GB/35
Sounds like the diverter valve in the heater box and only comes complete Pt No. 488856. not a 5 minute job as the machine needs to be stripped down and if you search I think Martin has put a how to on this site.
Colin
Re: WASHING MACHINE PRICE 1973
I remember getting £5-00 discount from a local shop delivering in the company van and installing the machine in the evening used to make all of £10-00 for my hard work and was well pleased at the time
Re: Hotpoint Ultima WD860G
Unable to match part numbers on Hotpoint site http://www.hotpointservice.co.uk/hs/pag … ison_Table
Colin
Re: Hoover HNC 160-80
Sorry I don’t know this or have any info on the 160, on the 170 it shows the heater being fed via the exhaust stat they look very similar models and can let you have more info on that one
Colin
Re: GDA BF50B Dishwasher
No, You will need a torx 20 driver to turn the shaft on the timer to poss 58 to reset. sticking normaly caused by heater or stat. pm your email if you req more info
Colin
Re: Hoover HNC 160-80
No the small board is the start relay board, go for the element probably one of the stats but these are not available as as spare on their own so would be element only
Colin
Re: indesit IWD7168 F06
F06 Door lock fails to close / open, door lock PTC triac open
/ closed,
mains frequency signalfault, mains power signal fault
– Check for water leaks that may affect connectors J004 or J11
(three-phase) causing the relative contacts to short;
– Check Door lock terminal board (any problems due to
aggression caused by manufacturing chemical residues that may
cause short circuits);
– Check J004 / door lock wiring;
– Check door lock;
– Renew PCB.Re: BEKO DFN1000X One Touch dishwasher – not heating water.
Let me have your email and can send some info
Coli
