[Criscold]

Re: Diplomat HJA8630 Dishwasher

Have you managed to enter test mode

Colin

[Criscold]

Re: Beko S502

No only the thermal fuse that has been replaced by a cutout kit pt no 4410101001
Looking at the drawing it looks like the negative feed to the top & bottom oven elements is fed via the grill element ?

PM if you would like a copy

Colin

[Criscold]

Re: Bosch Tumble Dryer – WTA3204GB/09

Thanks Martin

Thought 0.018M was a little bit high

Colin

[Criscold]

Re: Tricitybendix WDR1040W

Yep thats correct and it states in the instruction book – At the end of these programmes the machine stops with the water of the last rinse left in the tub to prevent the fabrics
from creasing. To drain the water select programme “11” or “16”.

Colin

[Criscold]

Re: Tricitybendix WDR1040W

Yes this is correct

10 – 1 rinse with fabric softener, if required – Water left in the tub
11 – Drain Out

[Criscold]

Re: Electrolux EW12001 (914674010/01)

I think its doubtful that the timer knob would be at fault if the other programs are lining up and working correctly, I think more likely to be timer and this one comes complete with module mounted on top at about £47 + Vat from Qualtex and EMW do refurbished

[Criscold]

Re: electrolux esl 6115 d/w

Have you managed to get into diagnostics on this

[Criscold]

Re: Zanussi zwf1240w

Machine probably 5-6 years old, could be motor carbons

[Criscold]

Re: AEG favorit40010vi dishwasher

This may be worth a read

[Criscold]

Re: hpt vtd00 dryer wiring

pm your email and can send the info

[Criscold]

Re: Indesit IWDC6143UK

I had this a couple of months ago, check NTC on side of dryer duct for earth fault and also the one in the wash heater

Colin

[Criscold]

Re: zanussi zdf862w oven

Looks like you may have the wrong stat, part number looks like should be 3110945007 – ET52001/F8 for sn up to 117 – pm your email if you req drawings

[Criscold]

Re: zanussi zdf862w oven

No the hinges are not handed and have 2 listed – 3114227006 up to ser no. 117 & 3115676011 from ser 118.
The wiring info for the stat is confusing but if you connect the input from the timer to “A”, The Element+Neon to “B” And Fan to “C” on the replacement stat you shouldn’t have any problems

[Criscold]

Re: Zanussi ZWD12270W Washer dryer. Cuts out

PM your email and I will send you the details

Colin

[Criscold]

Re: Zanussi ZWD12270W Washer dryer. Cuts out

Have you tried getting into diagnostics to see if a last known error code is displayed + Insulation test on Heaters & Motor

[Author]

Posts