Forum Replies Created
-
Posts
-
Re: ctd 40
ok my idea did not cure it still have the same fault also when i put it on timed dry it runs for the set amount of minutes but the heater is normally not pulling amps it does sometimes kick in but not for long
this is a new stat kit the only thing i am unsure of is when looking on connect they list 2 different rear thermistors are they differently rated or just the same ?Re: ctd 40
thanks for the reply just to update i have had a further look in and found the float switch was wet and giving a readin in both states a quick blast with a hairdryer has cured that ..would i be right in assuming that in the event of a full water container the machine would just advamce through the cycle and trip out the element?
i have it on test now and will post the result but any other advice is welcomeRe: Unusual Hotpoint Condensor dryer fault.
Changed a few of the recently and have had one or 2 with dry joints on the relay for similar fault starts up no heat tap with screwdriver and gets heat flicker on my ammeter
Re: arctis
come on someone must have some idea
i set it to 0 degrees on friday and it is running perfectly at that temperature just wont allow to be set below that
is there some kind of config to do?
do i have to hit it with a stickRe: Hotpoint WF440
i can explain it
it was me i crept round in the night and fixed it
will send you the bill in the postRe: whirlpool awz 7913
well i still have this dryer and the front stat is an ntc and the element actually has 4 stats on it
if i relace the element will that cure my flashing light also does anyone have the error code list for this modelRe: New Washer Dryer (or used) recommendations please…
think it is time to stop with your current machine and just admit it is dead if it has gone pop it is almost a certaintity that the board will have been taken out with it
Re: What charge for entertainment?
£15 for dont you remember you fixed it before about 5 years ago and its never been right since
Re: Hotpoint WT721P
i would have to say pcb fault but i have worked on a lot of machines and have never seen the fault you describe
Re: What charge for entertainment?
how about a good old fashioned distraction such as can you go and fetch me some large towels so i can try it or can you go and turn your water off then get them to keep turning it off and on while you work in peace
or even send them outside so they can see if it is draining out properly
as for charges hout about a fiver every time a customer points to the door seal restraint band and says..”you have missed a bit”
in fact forget the cash i would rather just drop my toolbox on their overcrowding feet
