Forum Replies Created
-
Posts
-
Re: Whirlpool oven G2P90F/SS
Hiya,
Part number I’ve got is 4812 282 28209. Don’t quote me on it being faulty though, just what I’ve read in the diagram. 😕Brian
Re: Whirlpool oven G2P90F/SS
Hiya,
Had a quick look at the wiring diagram.
Live appears to be fed directly to the motor. Nuetral from the pcb.
There is a lower cavity temperature limiter on the nuetral to the pcb, check this limiter. 2nd Nuetral goes to the circular element.
If all is well I can only suggest you meter to check the wiring is ok.Brian
Re: belling DB90 thermostats
Go into “Diamond H Wiring Reference” sticky and download the pdf. It contains all the info I had to hand on various regulators. May well be of some assistance to you.
To try and help further we would need the model numbers of the switches.
brian
Re: WHIRLPOOL ADP 4400 DISHWASHER
Error codes are in the “Known error codes” sticky.
Count the flashes from the start light for the error code.
BrianRe: New tool for dealing with water escapage
We’re not supposed to leave any waste with a customer, even down to the paper towel stuff we use. Everything is taken away, old parts are sent back for disposal, waste is picked up by an outside company.
Brian
Re: prima hob fault code F03?
Whirlpool do the service on them. Been through all the models and no error codes are explained.
John Mac may know, hang around till he spots this one.
As an aside, Whirlpool ovens F03 indicates faulty electronic board. Did notice a couple of models have similar boards fitted.Brian
Re: Whirlpool ADG 6552 dishwasher
What have you checked? The flowmeter is at the bottom of the water matrix on the left hand side of the machine. Pull the plug off, clean the contacts, tighten the plug and put it back on.
Brian
Re: New tool for dealing with water escapage
BG have been using these for a few years now.
Absolutely brilliant item. Only drawback for me is having to carry them around in the van until the next pickup of waste. They smell terrible after a week or so, especially in the summer. 😆Brian
Re: Whirpool American F/F
Hiya,
CF is communication failure. Normally a fault with the front pcb.
Flashing lights and clicking are normally rear pcb.
Fridge not working could be a stuck / frozen damper valve.
85 number and serial number required to determine whether both pcbs are required.Brian
Re: Whirpool D/W APDW/1
Errors will be shown by the program lights. Should be 4 of them.
There are two versions of this machine, I’ll dig out the info for them tomorrow.Brian
Re: Whirpool D/W APDW/1
Hiya,
Fault codes for this one is a bit different.
Most errors give a single flash. You have to go into Service mode to get another fault code. Program leds will indicate the fault.Brian
Re: Whirlpool AWZ541
That’s the one John. He actually called me looking for the solenoid.
I’ve had a quick look online and the wiring diagram doesn’t make a lot of sense. 😕Thanks
BrianRe: AEG washing machine stops after 20 intermitantly code ‘E
Hiya,
Code is in the UKWhitegoods Fault code guide, well worth the money too. 😀
E84. “Sensing” circuit on circulation pump triac faulty (input signal to processor always 0v or 5v). PCB, Drain, cycle blocked (door open) OFF/Reset.HTH
Brian
