DentedPorsche

Forum Replies Created

Viewing 15 posts - 841 through 855 (of 915 total)
  • Author
    Posts
  • in reply to: Whirlpool Dishwasher – ADG 722 WH, replacement heater? #115287
    DentedPorsche
    Participant

    Re: Whirlpool Dishwasher – ADG 722 WH, replacement heater?

    Hiya, 3 flashes indicates a problem in the heating cycle of the wash.
    There are numerous things that can cause this, heater, thermostats, wiring and/or the module itself.
    The most cost effective way to repair this would be to get someone in to have a look at it.

    DP

    in reply to: Whirlopool ADP5966 #115422
    DentedPorsche
    Participant

    Re: Whirlopool ADP5966

    F2 indicates a water leakage into the base of the machine.

    DP

    in reply to: diplomat 8322 dishwasher potential problem? #116124
    DentedPorsche
    Participant

    Re: diplomat 8322 dishwasher potential problem?

    The tablet should disolve/break up whilst still in the dispenser. (The dispenser flap doesn’t fully open when the dishwasher door is closed, it only opens as far as the top basket allows). It is washed out/disolved by the water thrown up by the spray arms. As your’s is falling to the base intact when you open the dishwasher this indicates that either the spray arms are blocked, not rotating properly or the wash pump is faulty or partially blocked.

    DP

    in reply to: Indesit WE 16 – Error COde F-10 #116109
    DentedPorsche
    Participant

    Re: Indesit WE 16 – Error COde F-10

    F01 error is a motor and/or module problem.
    As Martin said, best get the experts in.

    DP

    in reply to: Code required for Whirlpool ADP 2756 WHM dishwasher #116113
    DentedPorsche
    Participant

    Re: Code required for Whirlpool ADP 2756 WHM dishwasher

    Hiya,

    F7. Flow meter failure. Flow meter defect. Water inlet valve defect or water inlet hose blocked

    Hope this helps.

    DP

    in reply to: Whirlpool dishwasher control pcb’s #115509
    DentedPorsche
    Participant

    Re: Whirlpool dishwasher control pcb’s

    Hiya Dave,
    I’ve emailed a spreadsheet to you with regard to the modules.
    Hope it’s of some use to you.

    DP

    in reply to: Hotpoint WD63P Washer/Drier #115665
    DentedPorsche
    Participant

    Re: Hotpoint WD63P Washer/Drier

    Thanks for that Tony, you’ve just explained the problems I’ve been trying to cure. I’ll just print out your reply and send it to the boss man at work, put the ball back in his court.

    DP

    in reply to: Blomberg 1501 brushes #115810
    DentedPorsche
    Participant

    Re: Blomberg 1501 brushes

    Don”t know if this is any use to you but I’ve got a blomberg washing machine to dump tomorrow and another blomberg motor sitting in my house.
    One in the house is Selni. Blomberg nr 10 131 20

    DP

    in reply to: whirlpool AWZ 650 cond. dryer #115779
    DentedPorsche
    Participant

    Re: whirlpool AWZ 650 cond. dryer

    Hiya,
    There’s numerous versions of this model but if you take off the front plinth it should be just below the door and to the right.

    DP

    in reply to: Whirlpool ADP934 dishwasher #115668
    DentedPorsche
    Participant

    Re: Whirlpool ADP934 dishwasher

    Hi Ray,
    This may well help you diagnose the problem

    http://s11.yousendit.com/d.aspx?id=6AF5 … C7CC0629FF

    DP

    in reply to: Whirlpool Washer/Dryer AWZ412 #115521
    DentedPorsche
    Participant

    Re: Whirlpool Washer/Dryer AWZ412

    Had a Servis based one a while back that wouldn’t fill but if timer was moved on a step or two it would. Wouldn’t spin either. Fault was a blown heater element. Haven’t got a clue as to why this caused the fill fault but replacing the heater cured it.

    SP

    in reply to: Whirlpool ADP934 dishwasher #115666
    DentedPorsche
    Participant

    Re: Whirlpool ADP934 dishwasher

    Whats the 12nc Ray? The model number shows me a mechanical timer machine.

    DP

    in reply to: Whirlpool ADP5966 Dishwasher Start Light Flashing #114285
    DentedPorsche
    Participant

    Re: Whirlpool ADP5966 Dishwasher Start Light Flashing

    To add to Dave’s post, once you’ve got the machine drained and working again have a look at the drain hose and reroute it so that it lifts up as high as the sink overflow. This will go a long way to preventing a repeat of the backflow into the dishwasher.

    DP

    DentedPorsche
    Participant

    Re: Ariston Margherita 2000 ( AWD 10 UK ) Problem – please h

    5 flashes indicates a pressure switch problem. You need to check for blockages. As your machine isn’t draining properly I’d suggest starting with the filter and hoses.

    DP

    in reply to: Hoover WDM130 Washer/dryer #115525
    DentedPorsche
    Participant

    Re: Hoover WDM130 Washer/dryer

    Totally agree with Kwatt on this one.
    Recently attended 2 heavy duty domestic machines, one in a nursing home the other in a guest house, and warranty was void despite customers being told by large retail electrical store that it was a commercial machine. (There were large labels stating “Domestic” on the appliances).
    Best bet is to ask the store to give you a proper written guarantee for commercial use when you buy it. Watch how many sales people suddenly change their mind about it.

    DP

Viewing 15 posts - 841 through 855 (of 915 total)