Forum Replies Created
-
Posts
-
Re: april fools day…..ive a washer in my shower room ..!!!
whenever I come across these they always pull the “well the plug is outside the bathroom” one. like so what? what difference does that make?
Re: indesit group spares prices
yes and existing thread was started at the time.
http://www.ukwhitegoods.co.uk/modules.p … ic&t=41111Re: Miele G646sc Dishwasher
is the circ pump running for that initial 10 secs? If not it may be siezed and causing the flashing light as the high pressure pressure switch is not revieving its signal.
If not then you may be right about re setting its, its a complex proceedure, one of the miele experts might be able to explain it better.Re: SMEG D/W E9
must admit to never had a problem with a flow meter model, most smegs manage without them. Would have thought water level should be well below the bottom arm swivel thing. 45 cm smegs dont play to the same rules as the 60 cm, my heart sinks when I walk in the kitchen and see one. Most 60cm overfills are module problems. Assume it is behaving now then? maybe poor connection to the flow meter?
Re: Diplomat ADP8352
0120800660 is the part number of the hinge complete, inc that bar,
all the bits are:012G9380559 HINGE RIGHT HAND 1
012G9380558 HINGE LEFT HAND 1
012G8080007 HINGE SHAFT 2
0120600060 HINGE PIN PUSH ON FIXING CLIP 2
0120800660 HINGE ASSEMBLY COMPLETE 1Re: Hotpoint WD440 Blocked Dryer Assy ?
have to wonder why indesit find it nesesary to put a filter in such a place, Prove me wrong but I cannot think of another washer dryer that has one other than older Indesits that had a horrid metal gauze affair in the rear of the drum where the condenser joins it. Surely not there just to make work for themselves is it?
Re: ISE10…covered by guarantee?
the mesh on the filter is very fine and can be completely blocked even when apparently clean. Hold it up to the light and you will see how blocked they get. A wash under the tap is usually the best method. I have never come across this fluff on fan fault though…. and that filter and door arrangement has been adround for years AFAIK un alterered.
Re: Smeg F/F S30STRP Saga Conttinues See Photos
laurence, is there no FAB model number quoted? The article number doesnt work either. there is a smeg S30STRP manual but there are no diagrams and the hinge is not listed. Usually the article number cross refs to a FAB number but all the article numbers are 750***
Re: Hotpoint WD440 Blocked Dryer Assy ?
Turbo wrote:Went back and cleaned the filter out working fine now, may bin the filter the next time it happens.
Thanks for all the help.
Grahamthat’l be next month then 😆
Re: hotpoint WM19 motor
iadom wrote:Can’t you just change the armature?
Jim.
yes but how would that fix a busted support bracket?
Re: Hotpoint WD440 Power Module Situation
yes, the 2008 TDS was the last….Pro corner is not just for agents, it is for Distripart account holders though and if you are and do not order using it they threaten to take it away! oh and dont ever try to use it at weekends, it never works despite the 24/7 promise on the front page.
as for connect and their being oh so willing to supply the hardware key and the smart card programmer but little else, they have ignored all my mails regarding the back up to go with it.
