Forum Replies Created
-
Posts
-
Re: ASKO WM200
the one nearest the front should be 80532231 and the rear most is 8053696 connect list them but only as special orders.
Re: Slowdown in Payments Received
Alex, had the same issues lately, the payment notification used to arrive on or just before the date payments were in my account but now that is not the case, often its 2 weeks or so later when payments appear on my statement.
However, that BACS payment advice has always come from their Collindale office, hence the 0208 phone number. Dont think there is much change there.Re: Frost free needs defrosting
Probably an electronic control problem. Not too expensive to fix on this one.
Re: Indesit c239 Fridge-freezer problem
That model uses a diverter valve which is controlled by the electronic pcb. Could be either at fault or one of the sensors. Not easy to diagnose. The PCB is around £50 + fitting to give you an idea of cost.
Re: Miele G646SC plus filling/drain problem
The ‘set point’ will not change but the way the machine measures its water, by air pressure, is probably blocked hence the overfilling and not knowing its empty. You may also have burned out the heater if you keep trying to use it. Its a specialist appliance this one and would recommend calling an engineer.
Re: Hotpoint wma50p – wiring help!
Most of us here have to work without such luxuries due to the manufacturers stance on service info. Which is why we always carefully note wire positions before removing anything. Would really suggest calling in an engineer to help you. Whatever you do dont guess at it.
Re: hotpoint aquarius 1200 wm 64 rattling on spin
More than likely it is a coin or something under the inner drum. Use a torch and look through the holes in the drum (go on stick your head in the door like I do!) and try and locate it. You may be able to coax it out through the gap between the door seal and the drum. Or push it into the filter trap in the sump hose and out of harms way.
Worse case would be the heater come loose. Either way may need a drum strip down to remove or investigate. Not really a diy job.Re: indesit wd12x wont move of program ?
Could be a duff heater, although that normaly causes the program to abort after a certain time.
Re: LG WM16220FD Bearing change
Try SEME for the parts their LG Parts are more realistcly priced, dont know that model myself, but if its the direct drive, the motor comes off easily (can even leave the coils on if you are carefull.) and drum out the front for splitting. Easier than a WMA and far easier than a Zanussi.
Re: HYGENA APP4210 COOKER HOOD
would you mean APP2410 by any chance? if so it W0000025 and a common failure.
Re: ERT
well, it seems i cannot read a copy of ERT without a “Mr Heath said this” or a “Mr Conway added” even a “Mr Watt says” this time, give us a break chaps 😆
Re: Bosch WFL2860 W/machine – Not filling properly
Is there a problem with it other than that, like poor wash or lights flashing? If not then its probably not a problem. Often they fill higher on rinse and delicate programms so check it on another programme and see what happens. If its not filling as fast as it used to, the dipsenser top section may be blocked but its not usually an issue on these machines.
